Galmet SGS Fusion 100 Installation And Operating Manual - Page 6

Browse online or download pdf Installation And Operating Manual for Boiler Supplies Galmet SGS Fusion 100. Galmet SGS Fusion 100 12 pages. Layered tank for dual function gas boilers

Print Page

3. Troubleshooting / 4. Technical specification

3. Troubleshooting

PROBLEM

The safety valve does not open

{even doing a blow through).

Safety valve leaks.

Water from the water heater is dirty.

Warning!

1. At least once every 18 months replace the magnesium anode (keep the receipt for the magnesium anode). Regular replacement of the magnesium

anode is a requirement for maintaining a warranty on the tank (for an enamelled tank).

2. It is not allowed to install the water heater without a properly functioning safety valve.

3. The safety valve must be installed directly in front of the cold water pipe leading to the water heater. Only valves approved by the Technical Supervision

Office, designed for capacitive water heaters, can be used – ones with a return valve. The safety valve allows water to flow out of the heater, if an

excessive increase in pressure in the heater occurs – opening pressure of 0,67 MPa.

4. No additional device can be installed between the safety valve and the water heater (e.g. shut off valve, water valve, etc.).

5. The repair method is specified by the manufacturer.

6. In the event of product defects importer. Free repairs of damage, for which the manufacturer is liable, will be remedied within 14 days from the date

of notification. THE WATER HEATER MUST NOT BE DISASSEMBLED. The receipt for the purchase of the water heater must be kept for after sales service

purposes. The number of repairs does not include gasket replacements, magnesium anode replacements etc.

7. A properly filled out, complete and in no way corrected warranty card is the basis for having repairs done under warranty (it must be kept throughout

the warranty period).

8. Cases not covered by the above conditions are subject to the provisions of the Polish Civil Code.

9. Connections with the heaters must not be made of plastic pipes not designed to work at a temperature of 95°C and at a pressure of 1,0 MPa.

10. Water heaters must be installed in such a way as to ensure easy access (e.g. for maintenance, repair or replacement).

11. The manufacturer is not liable for any inconvenience or expense caused by the dismantling of additional housing elements.

1. In case water becomes odorous or darkly coloured, this is caused by the formation of hydrogen sulfide by sulfate reducing bacteria that live in oxygen

poor water. If cleaning the water heater, replacing the magnesium anode and setting the temperature above 60°C do not improve the situation, we

recommend the use of a titanium anode connected separately to the power supply.

4. Technical specification

Specification

storage capacity

Tank's maximum working temperature

Tank's maximum working pressure

Magnesium anode - top cover 5/4" plug

Height

Internal diameter

External diameter

Net weight

According to the (EU) 812/2013, 814/2013.

Installation and Operating Manual - SG(S) Fusion

CAUSE

Safety valve seized.

Touching surfaces of safety valve dirty or

defective.

Excessive water pressure in the network.

A large amount of sediment in the tank.

Worn out magnesium anode

unit

°C

MPa

METHOD OF ELIMINATION

Clean or replace the valve.

Clean or scrub the touching surfaces of the safety valve.

Instal a flow control device.

Clean the tank of sediment.

Replace the magnesium anode - not covered by the warranty.

SG(S) Fusion 100

104

25x390

900

500

600