Galvin CliniLever Series Product Installation Manualline - Page 3
Browse online or download pdf Product Installation Manualline for Kitchen & Bath Fixtures Galvin CliniLever Series. Galvin CliniLever Series 4 pages. Hospital swivel wall outlets
Print PageINSTALLATION
IMPORTANT: Galvin Engineering products must be installed in accordance with these installation
instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water
and/or electrical supply conditions must also comply to the applicable national and/or state standards. Failing
to comply with these provisions shall void the product warranty and may affect the performance of the
product.
1. Fit tap assembly
Remove the spout from the wall elbow
using a hex key. This is to enable easy
installation and prevent the spout being
damaged
3. Refit the spout
Refit the spout to the elbow. Tighten
the grub screw using a hex key.
Note: Do not overtighten grub screw.
Ensure spout swivels freely once installed.
2. Connect
Place the wall flange over the elbow. Fit the elbow
to the protruding wall spud.
using thread tape or an equivalent to ensure the
connection does not leak.
Ensure spout connection is pointing up (vertical).
4. Testing
Turn on the water supply and test for leaks.
Version 1, 24 August 2018, Page 3 of 4
We recommend