Coral Box QP-9 User Manual - Page 2

Browse online or download pdf User Manual for Aquariums Coral Box QP-9. Coral Box QP-9 4 pages. Wireless controller for quiet pump

Print Page

III.

Operation and Function

Control panel of wireless controller

Fig.2

1, Button and Function of LCD Display

MODE/NIGHT

: Press the button to select different modes：F1，F2，F3，F4，

F5， Timer， F7 and enter to the direction of Night mode by long hold-down the button .

FREQ/REVERSE: Press the button to adjust the frequency '+' or '-'and change the

direction of the '<' and'>' by long hold-down the button.

WI-LE/RESET: Press the button to select Master control 'M', Slave control 'S',

Operate individually control 'N' and enter to Reset mode by long hold-down the

button only for Timer.

TIMER:

AND

: Press the button to adjust the flow rate when you are at

FI,F2,F3,F4,F5,F7 mode. But if you are in Timer UP and Down will becomes a

selection function.

Attention : If you operation on the Night Mode, it cannot

change any mode / Feeding until to cancel the Night

Mode

2, Function Description

Wireless controller is defined to allow operation without the wire among wave

makers.

MASTER Control ： Press "Wi-LE/RESET" once and enter into Master control

when LCD display "M" on the Wi-Li. Master controller can operate all the

functions for the Slave Control. Press" Wi-LI/RESET" until the LCD display

"F" on the Wi-Li. and enter into Follow mode , where all operation is invalid.

Among two or more wave makers, set one as the Master and the others as

Follow. You can achieve the same function and operation for all the pumps by

adjusting the Master controller.

3 、 Introduction of each mode

F1 ： Constant Flow Mode

One or more pumps can operate at the same time. In constant flow, flow rate

can be adjusted by "

and

F2: Wave Mode (WaveBox Function)

Press the "FREQ/REVESE" button is necessary when operate this mode to

adjust the wave patterns among one or more pumps at the same time. As the

volume of water in tank is different from the capacity of the tank, wave period

needed to be adjusted by pressing the button. The wave is biggest when wave

length turn to be same as the length of tank; Increase the wave length by pressing

the button increase the number or otherwise reduce the number.

Tips: You should press the "FREQ/REVESE" button gradually and notice the

wave pattern in a certain period after each adjustment. Press "

adjust the flow rate.

F3: Shift to Wave mode

Two pumps are needed to be operated at the same time, when they shift wave

and flow in cycles. P1 work, P2 stop;P2 work, P1 stop;P1 work, P2 stop. and

AND

" to