Galvin Engineering GalvinSafe 190.82.11.90 Product Installation Manualline - Page 5

Browse online or download pdf Product Installation Manualline for Plumbing Product Galvin Engineering GalvinSafe 190.82.11.90. Galvin Engineering GalvinSafe 190.82.11.90 7 pages. Pedestal floor mtd, axion msr eye/face wash head, s/s bowl, hand & foot act

Print Page

TROUBLESHOOTING

PROBLEM

1. No Flow.

2. Insufficient water flow

3. Eye/face wash streams do not meet

desired eye level.

4. Water does not drain properly.

For more information about GalvinSafe

Check the main shut-off valve.

2. a. Verify minimum 210 kPa flowing

supply line pressure.

b. Probable clogging of flow control due

to inadequate line flushing. Unscrew

eye/face wash head and remove the

four screws to disassemble head.

Clean flow control and reassemble

Head.

c. Remove plug located on L – Strainer

using a 9/16" wrench to access clean

filter screen.

3. Possible blocked flow control, see above

solution. Possible non-leveled eye/face

wash assembly

4. Check the main waste line of your

building to see if it does handle the

capacity required for the entire drainage

system.

(Haws) products, see our website.

Version 4.1, 13

Aug. 2021, Page 5 of 7

REPAIR CHECKLIST