AGS Merlin 1000SW+ Installation Operation & Maintenance - Page 8
Browse online or download pdf Installation Operation & Maintenance for Controller AGS Merlin 1000SW+. AGS Merlin 1000SW+ 12 pages. Gas, electric & water isolation controller
Also for AGS Merlin 1000SW+: Installation & Operation Manual (16 pages)
Print Page
Installation & Operation Manual
Switch Settings – Auto Reset
When power is restored after the power cut/ loss, the panel has to be restarted
OFF
manually. (Default)
This will instruct the system to restart automatically when power is restored after
ON
power cut/loss.
Switch Settings – BMS Integration
The panel can be integrated with a BMS to make or break a circuit when the gas is either on or off,
(valve open or valve closed). This will tell the BMS whether power is being sent to the solenoid valve.
OFF
Signals the BMS when gas is on or gas is off. (Default)
Signals the BMS on a fault i.e. high gas levels detected, emergency shut-off
ON
activated etc.
Switch Settings – Automatic Shut Down Timer
The system has an auto-shut down feature after a selected time.
There are two switches located on the circuit board labelled [TIME1] & [TIME2].
These can be configured to select the required timeout/ shut-down period.
TIME 1
OFF
ON
OFF
ON
Upon timeout the gas supply will be turned off unless other utilities are configured.
Switch Settings – Utility Shutdown Selection
There are two switches located on the circuit board labelled [ELECTR] and [WATER].
They are factory set to 'Off'.
On installation, they can be switched 'On'. This will instruct the system to also turn off Electric
and/or Water services when performing auto-shut down/ timeout.
Rev: 15
08-22
TIME 2
OFF
OFF
ON
ON
Timeout Period
2 Hours (Default)
4 Hours
8 Hours
Disabled
Merlin 1000SW+i
8