Corally C-00254 Quick Start User Manual - Page 5

Browse online or download pdf Quick Start User Manual for Toy Corally C-00254. Corally C-00254 19 pages. 1/10th scale elctronic ready to run
Also for Corally C-00254: Quick Start User Manual (17 pages)

Print Page

LIPO BATTERY SAFETY PRECAUTIONS

• Follow and respect the manufacturer's instructions for use

• It is important to check that your ESC is set to LIPO if you are using a LIPO battery. Failure to comply with this instruc-

tion will result in increased battery discharge and may cause fire and damage to persons and property.

• When charging or storing LiPo batteries always use LiPo Safety Bag (Flame retardant).

• Always respect the maximum rate and voltage specified by the battery manufacturer.

• Charge the LIPO battery outdoors or in a ventilated area away from flammable objects and surfaces.

• NEVER leave your LiPo battery unattended while charging.

• If the battery swells during charging, stop charging immediately and disconnect the battery from the charger. Leave

the battery outside for a few hours and observe. Then recycle the battery according to the instructions of your country/

region. Never dispose of a LIPO battery with domestic waste.

• Before recycling your defective battery, it must be neutralized. Take a plastic container, fill it with water and add a lot of

salt until the water becomes opaque. Place the LIPO battery in the water and leave for 24 hours. Check with a voltme-

ter that the voltage is 0.0V. Then recycle the battery according to local regulations.

• Never charge a damaged or inflated battery.

• Never discharge the battery cells below 3.2V.

• Always use the appropriate balancer/charger when charging your LiPo battery pack.

• When the battery is empty, check the temperature of the battery before charging it.

If the battery is very hot, wait until it cools before charging it.

• Never charge a very hot battery as this may cause an explosion or fire.

• When the battery is empty, recharge it immediately. Do not store an empty battery, the battery will continue to dis-

charge, it will fall below the minimum voltage and become unusable.

KIT CONTENT (Depends on the selected model)

Transmitter

REQUIRED FOR OPERATION (Not included)

4x AA Batteries

for the Transmitter

Hex Drivers

1.5mm

2.0mm

3.0mm

RTR Model (Chassis with Body)

2S - 7.4V LiPo Battery

3S - 11.1V LiPo Battery

Cross Wrench

User Guide

Charger

Silicone Oil

(for maintenance)