Galvo Shed GVO 1515 Assembly Instructions Manual - Page 3

Browse online or download pdf Assembly Instructions Manual for Outdoor Storage Galvo Shed GVO 1515. Galvo Shed GVO 1515 8 pages. Sloping roof shed

Print Page
STEP 1

DOOR ASSEMBLY

Attach the 780mm 'U' channels
at the centre ribs only. Attach the 1920mm 'U' channels
A
through the top and bottom channels
in the centre of the door sheet, slipping it under the two side 'U' channels and fixing it to
the sheet ribs and the side 'U' channels. Attach the hinges
top and bottom of the door through the 'U' channels. The fixings should be centred on the
side 'U' channels.
Turn the door over and fix the four corners through all the 'U' channels (step 2 below).
Fit the door bracing from the bottom corner to the opposite centre to the top corner
(see step 7 on page 6).
150MM
STEP 2
HANGING THE DOOR
Attach the first 'Z' door jamb
pan. Lay the premade door face down on the 715mm sheet
the bottom and down from the top. Check the door is centralised on the sheet (top and
bottom). Fix the hinges through the side of the 'Z' door jamb
4mm off the 'Z' door jamb.
4MM
GAP
If you choose to vary from these instructions your warranty will be impaired
to the top and bottom of the door sheet
J
at the four corners. Attach the door plate
J
HINGES
The hinges should protrude
over the top of the channel
N
to the 715mm sheet
L
NARROW PAN
30MM
to the door sheet
H
approx 150mm from the
N
H
J
on the rib with the narrow
B
approx 30mm up from
B
raising the door about
L
YOU WILL NEED
1 x 1920mm x 780mm door sheet
A
H
2 x 1920mm 'U' channels for door sides
A
2 x 780mm 'U' channels (door top
J
and bottom)
M
M
1 x 310mm door plate
N
Hinges
O
Door bracing
M
A
H
YOU WILL NEED
B
1 x 1980mm x 715mm sheet for front wall
1980mm 'Z' door jambs without
L
channel attached
B
L
J
3