Galvo Shed GVO 3030 Assembly Instructions Manual - Page 2
Browse online or download pdf Assembly Instructions Manual for Outdoor Storage Galvo Shed GVO 3030. Galvo Shed GVO 3030 8 pages. Gable roof shed
Print Page
COMPONENTS CHECKLIST
Please check all components carefully and advise your supplier immediately if any discrepancies.
Remember to quote the code on the front page.
A
2 x 1770 x 780mm door sheets
E
4 x 1960mm angle cut sheets &
2 x 2025mm gable cut sheets
(end walls)
I
2 x 2290mm 'U' channels for end
walls (top)
M
4 x 1600mm 'L' flashings
(roof to side flashings)
Q
4 x door bracing
IMPORTANT!
• Remove the swarf (drill filings) from the panels as you assemble them.
• All components are cut to length. Do not cut any parts unless instructed.
• Fixings through the inside of the channels into the sheeting are just as important as
fixings from the outside.
RIBS AND PANS
• Generally most fixings are spaced at 300mm apart.
• Keep the fixings in the pans as close to the ribs as possible for added strength.
• Ribs will always protrude to the outside of the shed.
• Extra internal fixings are strongly recommended in high wind areas.
BUILDING YOUR SHED
• The basic task is to join the sheets together to
form your panels, and fix channels to the top
and bottom of these panels. They will then join
together to form your shed (diagram 1, 2, and 3).
2
B
2 x narrow 1830 x 715mm sheets
(beside door)
F
4 x 3000mm 'U' channels with
ends cut for front and back walls
J
4 x 1770mm 'U' channels
(door sides)
N
2 x 1830mm & 1 x 1770mm 'Z'
door jambs (front)
R
1 x 3000mm long ridge beam (roof)
DIAGRAM 1
1
C
4 x 1830 x 780mm (back wall)
G
4 x 3000mm 'U' channels for roof
K
2 x 1586mm 'U' channels
(door spacers)
O
2 x 310mm door plate
S
2 x 2 gable plates for gable ends
DIAGRAM 2
If you choose to vary from these instructions your warranty will be impaired
D
8 x 1600mm x 780mm sheets (roof)
H
2 x 2255mm 'U' channels for end
walls (bottom)
L
4 x 780mm 'U' channels (door top
and bottom)
P
1 x pack screws with padbolts
1 x pack of rivets and hinges
PAN
DIAGRAM 3
RIB