Coram Showers PREMIER Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Shower Cabins Coram Showers PREMIER. Coram Showers PREMIER 4 pages. Double sliding door / side panel
Also for Coram Showers PREMIER: Manual (16 pages)

Print Page
Check contents of pack before installation. If anything is
missing, contact our Customer Careline for assistance.
CUSTOMER CARELINE: 01746 713410
1
a
=
100mm
max
a: Drill holes in both wall channels at points shown (in the groove) using a 4.5mm drill bit.
b: Ensure the shower tray is level in all directions. IMPORTANT: Clean the tray and seal the gap between the tray surface and tiles. It is
important that the tray is sealed right up to the tray edge so that the bottom of the wall channel is sealed. Failure to do this will cause water to
leak under the wall channel and between the tray and tiles, resulting in damp patches on the wall and under the tray.
2
a
X
3mm
min
X = Side Panel (S/P) widths - 700 S/P = 650 - 700mm
a: Place wall channels on the tray ensuring they are vertical and a minimum of 3mm back from the front of the tray. Place masking tape against
the wall before marking drill hole positions, this will help prevent the drill bit slipping. Drill 6.5mm holes, 30mm deep and insert the wall plugs.
b: Apply sealant to the back of the wall channels and around the fixing holes. c: Fix the wall channels to the wall using 8 x 32mm screws.
2
PN3222
6
10mm
PN50359
3
Cover
strip clips
100mm
=
=
ø 4.5
mm
ø 6.5
mm
760 S/P = 710 - 760mm
●
b
max
b
800 S/P = 750 - 800mm
●
PN11032
PN11030
c
32mm
900 S/P = 850 - 900mm
●