GAMA RF120VPR1L Instruction Manual

Browse online or download pdf Instruction Manual for Receiver GAMA RF120VPR1L. GAMA RF120VPR1L 3 pages. Rf receiver

GAMA Electronics, Inc.

P.O. Box 1488 Crystal Lake, IL 60039

Overview:

The RF120VPR1L is an RF receiver operating at a fixed frequency of 340 MHz. The receiver operates from 120VAC and

provides one polarity reversing output for use with a four/six lead AC motor. The receiver is not designed to operate with

any existing hand or drum switch. The receiver is equipped with a manual toggle switch. An additional latching output is

available for connecting to a 120VAC light. Up to twelve, three-button keyfob transmitters can be used to activate the

receiver's relay. The receiver has a terminal block for connecting the power and relay contacts. Each transmitter has a

unique address that is transmitted when a button is pressed. A "program" button is provided on the receiver to program the

transmitter(s) address into the receiver's memory. An LED on the receiver indicates the receiver's programming status and

illuminates when the receiver is energized. The receiver is encased in a waterproof enclosure. The operating range is at least

100 feet. Operating temperature range - 0o F to 160o F.

Polarity reversing output:

The transmitter has two buttons assigned to the motor output. The up (^) button runs the motor in one direction and down

(v) button runs the motor in the opposite direction. The reversing function is accomplished by reversing the phase on two of

the 4 motor connections at the receiver output.

Manual switch:

The receiver is equipped with a manual switch. This switch replaces any hand or drum switch previously connected to the

motor.

Light Output:

The light output is activated using the "B" button on the transmitter. Press button "B" once to latch this output on. Press

button "B" again to turn the light output off. The light function is active at all times and does not require the power up

sequence to be performed.

Maximum ratings:

Power for the receiver can be in the range of 100 to 132VAC. The relay contacts are rated at 20 Amps.

Dimensions:

Receiver dimensions are approximately 5.75" L x 4" W x 2.5" H.

Wiring:

The first thing to do is be sure there is no power at any of the motor terminals. Disconnect or turn off the circuit breaker to

remove power.

If a hand or drum switch is connected to the motor it will need to be disconnected. Take notes before disconnecting the

switch in the unlikely event it will need to be reconnected.

See wiring diagram.

120VAC power is connected to the L (line) and N (neutral) terminal of the receiver.

Look up your motor type in the table for motor connections.

NOTE: After completing the installation if the motor goes in the opposite direction as intended, simply swap the wires

connected to terminals 5 and 8 in the receiver. The motor will now rotate in the correct direction.

The 120VAC light connects between "COMMON" and "LIGHT" terminals on the receiver.

RF Receiver Model # RF120VPR1L Instruction Manual

TEL: (815) 356-9600

WEB: www.gamainc.com

FAX: (815) 356-9603