CORBERO TT 160 C Operating Instructions Manual - Page 8

Browse online or download pdf Operating Instructions Manual for Refrigerator CORBERO TT 160 C. CORBERO TT 160 C 14 pages.
Also for CORBERO TT 160 C: Operating Instructions Manual (14 pages)

Print Page

Clean the melting water outlet with the supplied pipe

scraper that can be seen in the figure. The pipe

scraper has to be stored in the outlet.

Occasionally check the defrost water outlet not to be

clogged up.

The most typical case of clogging up in the defrost

water outlet when you put food wrapped in some

paper into the appliance and this paper contacts back

plate of cooling compartment and freezes to it. If you

remove the food right at this moment the paper will

tear and it can cause clogging up in the outlet by

getting into it. So you are asked to be careful -

because of the above - when placing foods wrapped

in paper into the appliance.

In case of increased demand e.g. during

heatwaves, the refrigerator temporarily happens

to operate constantly - during this the automatic

defrosting is ineffective.

Remaining small ice and frost stains on back plate of

the cooling compartment after defrosting period is not

abnormal.

It is recommended to wash the inside of the

refrigerator in 3-4 weeks time.

Household cleaner or soap must not be used.

After you made it no-current wash the appliance using

lukewarm water and wipe it.

Clean the magnet door rubber profile with clean water.

After cleaning plug the appliance to the mains socket.

Dust and dirt collected on the back of the refrigerator,

condenser is recommended to be removed and clean

the evaporative tray on top of the compressor once or

twice a year.

In case the appliance will not be used for a long time

follow these steps:

Break the circuit of the appliance.

Remove foods from the refrigerator.

Defrost and clean it as written before.

Leave the door open to avoid a build up of air inside.

Should the light fail to work you can change it as

below:

Break the circuit of the appliance.

Unscrew the plate screw fixing the lamp cover, then

take the lamp cover off in the direction of arrow and

the bulb can be changed. (Type of the bulb: Mignon

322, 230 V, 15 W, E 14 thread)