GAMA Electronics RFAC-1L Instruction Manual - Page 2

Browse online or download pdf Instruction Manual for Receiver GAMA Electronics RFAC-1L. GAMA Electronics RFAC-1L 5 pages.

Print Page
GAMA Electronics RFAC-1L Instruction Manual
RFAC-1L
Instruction Manual
WWW.GAMAINC.COM

Programming Instructions

Each transmitter has its own unique address. The receiver needs to be programmed to respond only to the specific
transmitter it is intended to operate with. The following steps configure the receiver to operate with a particular
transmitter. Up to 12 transmitters can be programmed to one receiver. Please read the entire programming procedure
before starting.
1. Locate the pushbutton labeled "ON/OFF" on the receiver. Press and hold this button until the red LED on the switch
illuminates and blinks(approximately 3 seconds). The receiver is now in the transmitter program mode. Release the
button.
2. To configure the receiver, press and release the UP or Down button on the transmitter and verify that the red program
LED extinguishes and illuminates (blinks once).
3. Repeat previous step for additional transmitters that will operate with this particular receiver. The red LED on the
receiver will extinguish and illuminate (blink) once for the each transmitter that is programmed. The LED will rapidly blink
if a transmitter has already been programmed.
4. The receiver will return to normal mode if no transmitter buttons are pressed for 5-seconds. The red LED on the
receiver will blink rapidly, then extinguish. The receiver is now in the normal mode of operation. This completes the
programming instructions. The receiver will retain all of its programming even when power is removed.
Page 2 REV O 09/10/20