AGS Merlin 1000S Installation & Operation Manual - Page 10

Browse online or download pdf Installation & Operation Manual for Laboratory Equipment AGS Merlin 1000S. AGS Merlin 1000S 16 pages. Gas utility isolation controller
Also for AGS Merlin 1000S: User & Installation Manual (10 pages), Installation, Operation And Maintenance Manual (10 pages), Installation & Operation Manual (12 pages)

Print Page

Installation & Operation Manual

OPERATION

On connecting mains power, an LED on the front of the panel (AGS Logo) will illuminate red.

Turn the key switch to on position.

Turn the key switch to the off position to turn the panel off.

The emergency shut off button is located on the front of the panel.

There is also a facility for remote shut off buttons to be wired in series on the circuit board.

The emergency shut off button(s) will cut off the gas supply and electrics only when activated.

To reinstate the system, the emergency shut off button(s) will need to be reset and the panel

restarted.



Gas On

When the key switch is turned on, the Merlin 1000S will check the installation for gas leaks. If gas

proving is successful, the gas valve will open and the 'Gas On' LED will illuminate.

ON = Gas On

OFF = Gas Off



Testing

This LED will illuminate GREEN for approximately 30 seconds when the panel is checking the

integrity of the gas installation upon start up.

ON = proving the gas line, do NOT operate any appliances.

1000S IOM Rev: 07

01-20

Merlin 1000S