Gama Garden GT- 390 GT- 395 Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Tiller Gama Garden GT- 390 GT- 395. Gama Garden GT- 390 GT- 395 14 pages. Petrol powered cultivator

Print Page

Assembly

Warning!

When unpacking the machine, be especially careful not to

damage the clutch cable

Assemble the cultivator in accordance with the figures found

in the instruction manual

1. Assembly of the handlebar

The handlebar consists of the following:

Cross-tube (Figure 2, Item 1)

Clutch switch (Figure 2, Item 2)

Switching the reverse gear for the model Т 395 (Figure

2, Item 3)

Handlebar fastener (Figure 2, Item 4)

Handlebar fastening bracket (Figure 2, Item 5)

Handlebar fastening clamps (Figure 2, Item 6)

Note:

handlebar fastening clamp consists of two parts: upper

(Figure 2, Item 6 а) a n d l o w e r (Figure 2, Item 6).

1. Fit the holes of handlebar bracket together with the holes of the

cultivator frame (Figure 3, Item 1).

2. Take out 4 bolts, 4 nuts, 4 washers and 4 retaining washer

from the fastening set.

3. By the help of bolts, nuts, washers and retaining washers,

fasten the handlebar bracket to the cultivator frame.

4. Fit the hole found in the lower part of the handlebar fastening

clamp together with the hole of the handlebar bracket (Figure 2,

Item 6).

5. Take out the handlebar fastener from the fastening set (Figure

2, Item 4), a b o lt (Figure 2, Item 7), f i xin g s c r ew an d a

6а

Figure 2

Figure 3

washer.

6. Install the handlebar in the hole of the lower part of the

handlebar fastening clamp (round hole without teeth), and from

the top place the upper part of the handlebar fastening clamp

on it (Figure 2, Item 6а), fitting the bracket holes in the lower and

upper part of the handlebar fastening clamp.

7. Place the bolt in the holes fitted together (Figure 2, Item 7),

with the washer put on it previously by means of a key (it should

be purchased separately) and tighten it.

8. Place the bolt having a rectangular part under the head in the

other hole of the handlebar fastening clamp, put the flat washer

on it and fix it with the handlebar fastener (Figure 2, Item 4).

Adjusting the clutch cable

The clutch cable must be adjusted in the following cases:

In order that the clutch lever can be pressed to the

handlebar without special effort;

n order that the clutch cable is not loose

2.1 Order of adjustment (for the following model: GT

390)

1. Put the clutch lever in "1", "2" or "RH" position (Figure 4).

2. Press the clutch lever out to 1/3 of the free escapement

(Figure 5).

3. With the lever held in this position, draw the starter cord

slowly 2 or 3 times. The cultivator blades should start moving.

If the blades do not rotate:

Screw off the retaining nut of the adjusting sleeve (Figure 6, Item

1).

While turning the sleeve (Figure 6, Item 2) as compared to the

body (Figure 6, Item 3), determine the play of the cable as

compared to the wiring. Screw in the retaining nut.

Figure 5

Figure 4

Figure 6