Gama Garden GT-35 Instruction Manual - Page 6

Browse online or download pdf Instruction Manual for Tiller Gama Garden GT-35. Gama Garden GT-35 14 pages. Petrol powered cultivator

Print Page

Note: on the blades of the component,

embossed letters (L), (R) are found, meaning L- left-side

blade, R-right-side blade.

1. Setting the blades on the reducer

Place the blade holders (assembled with blades) on the

reducer shaft (Figure 9, Item 3) from both sides, fit the

holes of the reducer shaft with holes of blade holders, and

fasten them with bolt pins and cotter pins (Figure 9, Item 1

and Item 2).

Note: set the cutting edges of blades in the direction of

rotation.

4. Setting the handlebar

The handlebar consists of the following (see: Figure 10):

Right section of handlebar;

Left section of handlebar;

Cross-tube connecting the right and left side

Figure 10

Fit the fastening holes of the left side and right side of the

handlebar together with the holes found in the upper

section of the handlebar holder, then fasten them with

М8х100 bolts and nuts (see: Figure 11).

2. By means of a 4-mm key (not included in the scope of

supply),

Blades

nearer

the

reducer

Figur

e 8

Figure

screw off and remove М5х20 bolts from the clamps (see:

Figure 10) from the upper section of the handlebar,

preventing the nuts from falling out.

Set the proper part of the cross-tube in the holes of the

clamps, and fasten it with the bolts removed earlier.

Warning

When installing the handlebar, do not turn over or break the

control cable.

5. Adjusting the clutch cable tensioning

With the clutch lever being released (not pressed), pull the

pull starter handle several times. During this, the blades

should not turn over. If they still turn over, loosen the cable

tensioning by means of the regulating sleeve.

Loosen the fastening nut (see: Figure 12, Item 2) and

slightly screw the sleeve (Item 1) in the body (Item 3).

Strongly tighten the fastening nut to the body of the

regulating sleeve.

3. Check the clutch cable for tensioning.

Note: In the following, in case of the drive-belt's wearing and

elongating the tension can be set by means of the sleeve

which is found in the clutch lever body (at the beginning, the

sleeve is fully screwed in).

For tightening the clutch cable, screw off the fastening nut

(See: Figure 13) and slightly screw off the cable sleeve.

М8х100 bolts

Figure