Jade CHITWOOD SMOKE BROILER KC-24 Installation & Maintenance Instructions Manual - Page 6

Browse online or download pdf Installation & Maintenance Instructions Manual for Broiler Jade CHITWOOD SMOKE BROILER KC-24. Jade CHITWOOD SMOKE BROILER KC-24 10 pages. Chitwood real smoke broilers
Also for Jade CHITWOOD SMOKE BROILER KC-24: Features & Dimensions (2 pages)

Print Page

Movable Gas Appliances, ANSI Z21.69-(latest edition), and a quick-disconnect

device that complies with the Standard for Quick-Disconnect Devices for Use

with Gas Fuel, ANSI Z21.41-(latest edition). In Canada, the flexible connector

must be CGA approved and must comply with the CAN1 6.10.88. The quick

disconnect must comply with CAN1 69.9.M79. A restraint device must also be

installed (normally a cable) to guard against transmission of strain to the

connector. If a cable is to be used, it should be attached at the rear of the broiler

close to the right side.

Special care must be taken to ensure that the minimum clearances to

combustible construction are not reduced when the Broiler is rolled back into

position after cleaning or servicing. If it is necessary to disconnect the Broiler

while servicing, reconnection of the restraint device must be done after the

Broiler has been returned to its original position.

VENTING INSTRUCTIONS

CHITWOOD BROILERS are gravity-type, direct-fired Broilers that depend on the free flow of

air into and out of the area surrounding the Broiler for proper operation. As with all open

broilers, the Broiler must be installed under a Class "1" Hood, using a properly rated Ansul

System for indoor use, or according to local standards.

It is important that the total ventilation system within the kitchen area be well balanced in

order to prevent excessive drafts within the burner area of the Broiler. Frequently, pilot

outage problems can be traced to excessive airflow created by either an excessive amount

of make-up air or exhaust flow.

NOTE: No attempt should be made to operate this appliance during a power failure

when installed indoors, due to the lack of proper ventilation from inoperable hood

system.

LIGHTING INSTRUCTIONS

Light pilots next to top burners. Adjustments to pilot flame height is made by

turning the appropriate pilot valve on main manifold. Flame height should be

approximately 1/8" and pilot head should be no more than 3/8" from burner.

With all top burner pilots lit, turn on and off each burner flame to make sure

lighting occurs within four seconds. Adjustment for burner flame is make by

turning air shutter to increase or decrease air mixture. After adjustment is made,

secure air shutter set screw.

Light the smoke box pilot; it should stay on (if necessary, adjust as stated in Step

A). Now turn on the valve to smoke box burner. Check for proper ignition and

see that the smoke box clears all parts of smoke box assembly.

Reattach front face if removal was necessary during adjustments.

Reinstall bottom grates with flat side up and evenly spaced.

P/N 24-137 REV A 7/00

Page 6