aireRyder F0049 Manual - Page 5

Browse online or download pdf Manual for Fan aireRyder F0049. aireRyder F0049 8 pages.

Print Page

INSTALLATION INSTRUCTIONS

IMPORTANT:

BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE

SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN

DOUBT, CONSULT A QUALIFIED ELECTRICIAN.

THIS FAN MUST BE INSTALLED WITH A WALL CONTROL/SWITCH.

SAVE ALL INSTRUCTIONS.

NOTE: The fan weight is 25lb (11.4kg). Be sure the outlet box you are using is securely attached to the building structure

and can support the full weight of the fan. Failure to do so can result in serious injury.

Installation Steps :

Fig.1

Turn OFF the electric power at the

main fuse or circuit breaker box.

Fig.3

Lock Pin

Hanger Pin

Remove the Lock Pin and take off

the Hanger Pin.

Fig.6

Collar Screws

Insert and tighten the two Collar

Screws. Slide Lock Pin into Hanger

Pin until it locks into position.

Outlet Box

Hanger

Bracket

Fig.2

Fig.4

Motor Wires

Collar

Thread the motor wires through the

canopy, downrod stand cover and

downrod.

Fig.7

Lock Pin

Rubber Sheath

Hanger Ball

Thread the motor wires, safety

cable and grounding wire through

the rubber sheath, then fully

cover it to the hanger ball.

Chip

Downrod

Canopy

Downrod Stand

Cover

PAGE: 5 / 8

Tighten the hanger bracket to the outlet

box with 2 mounting screws. (To reduce

the risk of fire, electric shock, or personal

injury, mount to the outlet box marked

"Acceptable for fan support" and use

mounting screws provided with the outlet

box.)

Note: For slope ceiling installation, make

sure that the chip of the hanger bracket

is toward the floor.

Fig.5

Motor Wires

Hanger Pin

Loosen the collar screws in part way.

Insert the Downrod into the Collar.

Slide Hanger Pin through holes of

Collar and Downrod.

Fig.8

Hang the fan on Hanger Bracket, and

make sure the slot of hanger ball is

snapped into the chip of Hanger

Bracket exactly.

Note: For slope ceiling installation,

make sure the slot of hanger ball and

the chip of hanger bracket face down.

Collar Screw

Hanger Bracket

Slot

Chip

171120