aireRyder F0050 Quick Start Manual - Page 6

Browse online or download pdf Quick Start Manual for Fan aireRyder F0050. aireRyder F0050 9 pages. Original ceiling fan

Print Page

Green (Ground)

Fig.8

Safety Cable Hook

Safety

Cable

Hang the safety cable into the safety cable hook.

Fig.11

Blade Holder

Washer

Motor Screw

Remove the motor screws and

washers from the motor assembly.

Secure blade holders to the motor

with washers and motor screws.

Fig.13

Female terminal

male

terminal

LED Module

Screw

Make wire connections:

1). The white motor wire to the white wire from the outlet box with a wire connector.

2). The black motor wire to the black (hot) wire from the outlet box

with a wire connector.

3). The green (ground) wire from the downrod and hanger bracket to the ground

wire from the outlet box with a wire connector.

*** After making the wire connections, the wires should be spread apart with the

grounded wires on one side of the outlet box and the ungrounded wires on the

other side of the outlet box.

*** After the connections have been made, the wires should be turned upward and

pushed carefully up into the outlet box.

Fig. 9

Fig.11

Decorative Plate

Thread the blade screws

through the washer,

blade holder and blade into

the decorative plate. Tighten

all blade screws securely.

Repeat to other blades.

Connect the female terminals from motor to male terminals

from LED module.

secure the LED module to the motor by LED module screws.

Note: 1). The black fixture wire to blue motor wire.

2). The white fixture wire to white motor wire.

LED

Module

Fig.10

Key Hole

Slot

previous canopy screw and tighten the other canopy

screw. Attach the decorative cap to canopy, rotate it

counterclockwise until tight.

Fig.12

Blade Screw

Washer

Blade

Remove one set screw (for later use),

then push the glass holder upwards by

inserting set screw heads left in motor bottom

into key hole slot, rotate the glass holder till

the hole in glass holder aligns the hole in

motor bottom, finally, secure the glass holder

to motor bottom with previous set screw and

tighten the other two set screws.

PAGE: 6 / 9

Remove one canopy

screw (for later use),

then push the canopy

upwards by inserting

Hanger Bracket

canopy screw head

left in hanger bracket

Canopy Screw

into key hole slot,

rotate the canopy till

Canopy

the hole in canopy

aligns the hole in

Canopy Screw

hanger bracket, finally,

secure the canopy to

Decorative Cap

hanger bracket with

Glass Holder

Set Screw

171120