aireRyder FN52239 Manual - Page 6

Browse online or download pdf Manual for Fan aireRyder FN52239. aireRyder FN52239 11 pages.

Print Page

Fig.9

Collar

Reverse Switch

Big Notch

Housing Glass

Shade

Use the reverse switch to turn the fan

spin to difference direction.

Collar

Fig.12

Insert the hanger pin through the holes

in the collar and downrod. Insert the

lock pin through the hole near the end

of the hanger pin until it snaps into its

locked position.

Fig.15

Install the hang ball onto the downrod,

then insert the hanger ball pin through

the top hole of the downrod.

Fig.18

Secure the glass holder to the housing

glass shade using the screws provided,

but not over tighten.

Lock Pin

Set Screw

Collar

Hanger Pin

Fig.13

Tighten the downrod set screws on the

collar.

Fig.16

Tighten the hanger ball screw to the

downrod.

Make wires connections:

1) The white wire from the motor to the white wire from the receiver with a wire nut.

2) The black wire from the motor to the black wire from the receiver with a wire nut.

3) The blue wire from the motor to the blue wire from the receiver with a wire nut.

4) The red wire from the motor to the orange wire from the receiver with a wire nut.

5) The white wire from the outlet box to the red wire from the receiver with "AC in N"

with a wire nut.

6) The black (hot) wire from the outlet box to the red wire from the receiver with "AC in L"

with a wire nut.

7) The ground wire from the outlet box to the green ground wire from the motor with

a wire nut.

Make sure all of wire nuts are connected exactly.

*** After making the wire connections, the wires should be spread apart with the grounded

conductor and the equipment-grounding conductor on one side of the outlet box and the

ungrounded conductor on the other side of the outlet box.

*** After the splices have been made, they should be turned upward and pushed

carefully up into the outlet box.

Screw

Fig.10

PAGE: 2 / 5

Fig.11

Downrod

Collar

Glass Holder

House Glass

Shade

Thread the motor wires through the

downrod. Then insert the downrod

into the collar.

Thread the motor wires through the

downrod stand cover, canopy in order.

Fig.17

Hanger Bracket

Hang the fan on hanger bracket, and

make sure the slot of hanger ball is

aimed into the chip of hanger bracket

exactly.

Fig.14

Chip

090622