Gamber Johnson 7160-1313-00 Installation Instructions Manual - Page 4
Browse online or download pdf Installation Instructions Manual for Tablet Accessories Gamber Johnson 7160-1313-00. Gamber Johnson 7160-1313-00 6 pages.
Print Page
SAMSUNG TAB ACTIVE2 LIVING HINGE POWER SUPPLY INFORMATION
This docking station has an add on power supply and is designed to be used with a 12 volt or 24 volt DC systems only.
The voltage output is factory set at 5 Volts
IMPORTANT": Make sure that you have read this entire section before you begin wiring! Please refer to Figure 1
1.
Install docking station into the vehicle, making sure that all bolts are tight.
2.
Attach BLACK ground wire to the location where the vehicle battery grounds to vehicle chassis. (See Figure 1)
3.
Connect the RED wire to the supply voltage (V+) from the vehicle. (See Figure 1)
•
Use only SAE J1128 Type GPT number 16 AWG stranded wire(minimum) to attach the docking station to the vehicles electrical system.
•
Route the lead wires to the battery. Total wire in the circuit must not exceed 30 feet and must conform to SAE J1128 standard.
•
Protect the lead wires from the abrasion and chafing by using wire loom or conduit and route away from moving parts or areas where
high temperatures may occur.
•
Connection of supply voltage (V+) must be kept as close to the battery as possible.
•
Caution: For continued protection aginst risk of fire, replace only with the same type and rating of supplied fuse. The provided fuse is
rated at 2 amps and below 32 volt DC.
•
If a timing device is used, follow the instructions of the manufacturer of that device. It must be wired in-line with the supply voltage (V+)
to the docking station.
•
If you have any installation questions, please call Gamber-Johnson customer support at 1-800-456-6868.
Ground to Vehicle Chassis
Vehicle Battery
POWER SUPPLY INFORMATION
WIRING INSTRUCTIONS
IMPORTANT REMINDERS
16 AWG(black wire)
-
+
18237 INCLUDES FUSE
FIGURE 1
18237
POWER
SUPPLY
USB TO MICRO USB CABLE
DOCK
4/7