Gree NEO30HP230V1A Owner's Manual - Page 8

Browse online or download pdf Owner's Manual for Air Conditioner Gree NEO30HP230V1A. Gree NEO30HP230V1A 12 pages. High-wall ductless air conditioning & heating system
Also for Gree NEO30HP230V1A: Quick Start Manual (2 pages)

Print Page

TWD-0813-033 Neo Manual REV:Layout 1 9/27/13 11:15 AM Page 15

OPERATION OF WIRELESS REMOTE CONTROLLER

VERTICAL SWING LOUVERS

• Press the Vertical Swing Louver button to select five

different vertical (up & down) air discharge directions

including Continuous Sweep.The Vertical Swing Louver

icon will be displayed. Press this button to set

swing angle, which circularly changes as below:

OFF

Indicates louver swings back and forth in the five

places, as shown in the figure.

X-FAN MODE

When operating in humid areas, neo has a DRY COIL function

called X-Fan that will allow the indoor fan to run for a pre-determined

amount of time after the unit is turned off (cooling or dry modes)

to ensure that additional moisture is removed from coil. Push the

"X-FAN" button to enable this feature. The X-FAN

be displayed on remote controller. To deactivate this feature, push

the "X-FAN" button again.

TURBO MODE

The desired setpoint, either in heating or cooling, can be achieved

faster if TURBO mode is used. After selecting the "HEAT" or

"COOL" mode button, push the "TURBO" button. The TURBO

icon will be displayed on the remote controller and the unit

will run at ultra high speed fan. To deactivate the feature, push the

"TURBO" button again. The unit will return to normal operation.

Swing Louver Display

icon will

X-Fan Mode Display

Turbo Mode Display

OPERATION OF WIRELESS REMOTE CONTROLLER

SLEEP MODE

The neo will automatically adjust room temperature during

your sleep time. This slight change in temperature will not affect

your comfort level due to the natural effects that sleeping has on

the body, but it will save on energy consumption and will lower

your electric bill. Press the SLEEP button to select Sleep Mode.

The SLEEP icon will appear.

In Cool or Dry modes:

The unit will run at current room setpoint for 1 hour.

After 1 hour, the setpoint will increase by 2° F.

After 2 hours, the setpoint will increase by 4° F and

maintain this setpoint until Sleep Mode is cancelled.

In Heat mode:

The unit will run at current room setpoint for 1 hour.

After 1 hour, the setpoint will decrease by 2° F.

After 2 hours, the setpoint will decrease by 4° F and

maintain this setpoint until Sleep Mode is cancelled.

Sleep Mode Display