HIKOKI GP 3V Handling Instructions Manual - Page 15

Browse online or download pdf Handling Instructions Manual for Grinder HIKOKI GP 3V. HIKOKI GP 3V 20 pages. Electronic hand grinder

Print Page

5. Replacing a carbon brush (Fig. 5)

(1) Loosen the D4 tapping screw retaining the tail cover and

remove the tail cover.

(2) Use the auxiliary hexagonal wrench or small screwdriver

to pull up the edge of the spring that is holding down the

carbon brush. Remove the edge of the spring toward the

outside of the brush holder.

(3) Remove the end of the pig-tail on the carbon brush from

the terminal section of brush holder and then remove the

carbon brush from the brush holder.

(1) Insert the end of the pig-tail of the carbon brush in the

terminal section of brush holder.

(2) Insert the carbon brush in the brush holder.

(3) Use the auxiliary hexagonal wrench or small screwdriver

to return the edge of the spring to the head of the carbon

brush.

NOTE:

Make sure the end of the spring is not holding the pig-tail.

(4) Mount the tail cover and tighten the D4 tapping screw.

6. Service parts list

CAUTION

Repair, modiﬁ cation and inspection of HiKOKI Power

Tools must be carried out by a HiKOKI Authorized

Service Center.

This Parts List will be helpful if presented with the tool to

the HiKOKI Authorized Service Center when requesting

repair or other maintenance.

In the operation and maintenance of power tools, the

safety regulations and standards prescribed in each

country must be observed.

MODIFICATIONS

HiKOKI Power Tools are constantly being improved

and modiﬁ ed to incorporate the latest technological

advancements.

Accordingly, some parts may be changed without prior

notice.

NOTE

Due to HiKOKI's continuing program of research and

development, the speciﬁ cations herein are subject to

change without prior notice.