DYS DWA-2000A-SS Operating Instructions Manual - Page 9
Browse online or download pdf Operating Instructions Manual for Controller DYS DWA-2000A-SS. DYS DWA-2000A-SS 17 pages. On-line suspended solids controller
Print Page
DWA-2000A-SS
11. Measurement of SS
￭ Be sure to perform calibration before installation
When power is initially supplied, SS density values will appear real time on the FND.
-
When the RUN lamp blinks, it indicates that analog output (4~20mA) is generating
-
When it does not blink, the analog signal is not being produced.
-
At the time of entry into MODE function, the analog output (4~20mA) will be put on hold
-
automatically
12. Measurement of Temperature
1) Compensation of Automatic Temperature Compensation (ATC)
This function should be carried out when the calibration of temperature is needed.
-
Pressing the
The figures will blink when the
You can change the temperature by selecting either increase or decrease in temperature and pressing
the
key one at a time slowly
When completed, please press the
2) Input of Manual Temperature Compensation (MTC)
This function should be carried out when the calibration of temperature is needed.
-
The C-2 Mode will be displayed when the
The temperature value will blink when the
Input a value using
When completing the input of data, press the
※While the temperature is input on C-2 Mode, the ATC function will come to a stop.
Daeyoon Scale Industry Co.,LTD.
key three times will make C-1 Mode appear
key is pressed
and
keys.
Suspended Solids Controller
Caution
key
key is pressed four times
key is pressed.
key
- 9 -