AGT INDUSTRIAL AGT-B1000 Product Manual - Page 14

Browse online or download pdf Product Manual for Lifting Systems AGT INDUSTRIAL AGT-B1000. AGT INDUSTRIAL AGT-B1000 19 pages. Two-post auto lift

Print Page

7 - Troubleshooting Guide

Malfunction

1.Check the air switch.

2.Check if the voltage is

correct.

The motor does

3.The motor burned.

not work

4.Start switch burned.

5.Top limiter switch burned.

6. AC contactor burned.

1 .Pressure valve pressure is

too small.

The motor works

2.Pump station takes in air.

3. Hydraulic oil suction hose is

but can't lift

detached or broken.

4 . Insufficient hydraulic oil

1. Safety lock engaged

2. Other object inside the

Does not

columns stops the carriage.

lowering

3 . The flow valve needs to be

adjusted.

1.Dump valve failure.

2 .Hydraulic oil leaks.

Self- Lowering

3. The valve body of the power

unit has holes.

1.The voltage is too low.

Raise without

2. Objects in the dump valve.

load, but does't

3 . The pressure valve

raise with load

pressure is too small.

4 . Overload.

Lifting is not

1.The cables are not

leveled

balanced.

1.After raising to the highest

point, the motor is still working

and the top limiter switch is

Loud motor

disabled.

noise

2 . Hydraulic oil pollution.

3 .Overload.

Troubleshooting Guide

Possible reason

Page 14 of 19

Solution

1. Turn off or replace the air switch.

2. User correct power supply.

3. Replace the motor.

4. Replace the start switch.

5. Replace the top limiter switch.

6 . Replace the AC contactor.

1 . Colockwise adjust the pressure valve

( fine adjustment).

2 . Unscrew check valve on the power

unit, and then start the motor until

hydraulic oil flows out from the check

valve, then tighten the check valve.

3 . Install/ replace the suction hose.

4. Fill more hydraulic oil.

1 .Slightly raise the device and then

pull the safety lock release cable.

2. Check and remove the objects.

3 . Counterclockwise adjust the flow

valve( fine adjustment) .

1 Replace the dump valve.

2.Check and repair.

3.Replace the valve body.

1. Install the voltage stabilizer.

2. Remove objects from the dump valve.

3. Increase pressure properly ( fine

adjust the pressure valve) .

4. This operation is prohibited.

1. Balance cables by adjusting the

cables' length.

1. Replace the top limiter switch.

2 . Replace the hydraulic oil.

3. This operation is prohibited.