GAME SolarPRO 4512 Owner's Manual - Page 8

Browse online or download pdf Owner's Manual for Swimming Pool Heater GAME SolarPRO 4512. GAME SolarPRO 4512 12 pages. Pool heater

Print Page

INITIAL OPERATION

Once the solar heater has been assembled and the hoses are connected to the filter pump and pool return, unblock the flow of water

into the pool return hose and turn on the pump and filter system Bubbles will shoot out of the return nozzle into the pool initially

while air is pushed out of the solar heater If this persists for longer than 2 or 3 minutes, check for and repair any leaks in the hoses

or connections

To prevent damage, the solar coils should always be covered with the clear acrylic dome included in the package The solar heater

should not require servicing or maintenance other than winterizing Prior to the first frost, or at the end of your swim season, the

solar heater should be removed from its connections to the pool and stored in a frost free location

Cloth Cover

A dome cover is included which can be used to cover the solar heater during the hottest days when your pool water does not need

additional heating assistance

Winterizing

Drain all the water from the solar heater by disconnecting the tubes Store in a location protected from frost Reconnect the pool

return tubes with a 1½"-1½" coupler (not included) or any properly sized 2-way valve if continued pool use is desired

Do NOT allow standing water inside the solar heater to freeze. Water expands as it freezes and can rupture the solar coils on the heater.

Problem

Does not appear to be heating the

pool

No initial bubbling after heater is

connected and pump is on

Bubbles continue

to flow out of the pool water inlet well

after the pump has been turned on

Leaking heater

SAVE THESE INSTRUCTIONS

NOTE: Be sure to place your pool cover on at night to prevent heat loss.

Possibilities/Solutions

• Check to make sure that water is flowing through the tubes Check the flow strength at

the pool inlet

• Has it been sunny?

• Put your pool cover on at night to prevent heat loss

• Additional heaters may be necessary

• Check the setting of the filter to make sure it is returning water to the pool through the

pool water inlet

• Check flow rate

• Check the connections for a suction leak

• Check to make sure the flow rate is normal

• There could be a break in the tubing

• There could be a clog in the tubing, try to purge out

the clog

• Check the connector seals and replace or repair

if defective

CAUTION

Meijer.com