Airetool PATP-9400-P Operating & Service Manual - Page 2

Browse online or download pdf Operating & Service Manual for Water Pump Airetool PATP-9400-P. Airetool PATP-9400-P 20 pages. Pneumatic powered hydraulic pump

Print Page

IMPORTANT RECEIVING

INSTRUCTIONS

Visually inspect all components for shipping damage.

Shipping damage is not covered by warranty. If shipping

damage is found, notify carrier at once. The carrier is

responsible for all repair and replacement costs result-

ing from damage in shipment.

SAFETY FIRST

SAFETY ISSUES

Read all instructions, warnings, and cau-

tions carefully. Follow all safety precau-

tions to avoid personal injury or property

damage during system operation. Cooper

Power Tools cannot be responsible for damage or injury

resulting from unsafe product use, lack of maintenance

or incorrect product and/or system operation. Contact

Cooper Power Tools when in doubt as to the safety pre-

cautions and operations. If you have never been trained

on high-pressure hydraulic safety, consult your distribu-

tion or service center for a free Enerpac Hydraulic safety

course.

Failure to comply with the following cautions and warn-

ings could cause equipment damage and personal in-

jury.

A CAUTION is used to indicate correct operating or main-

tenance procedures and practices to prevent

damage to, or destruction of equipment or other prop-

erty.

A WARNING indicates a potential danger that requires

correct procedures or practices to avoid personal injury.

A DANGER is only used when your action or lack of ac-

tion may cause serious injury or even death.

WARNING: Wear proper personal protective

gear when operating hydraulic equipment.

WARNING: Do not exceed equipment ratings. Never

attempt to lift a load weighing more than the capacity of

the cylinder. Overloading causes equipment failure and

possible personal injury. The cylinders are designed for

a max. pressure of 700 bar. Do not connect a jack or

cylinder to a pump with a higher pressure rating.

Never set the relief valve to a higher pres-

sure than the maximum rated pressure of

the pump. Higher settings may result in

equipment damage and/or personal injury.

WARNING: The system operating pressure

must not exceed the pressure rating of the

lowest rated component in the system. Install

pressure gauges in the system to monitor

operating pressure. It is your window to what is happen-

ing in the system.

CAUTION: Avoid damaging hydraulic

hose. Avoid sharp bends and kinks when

routing hydraulic hoses. Using a bent or

kinked hose will cause severe back-pressure.

Sharp bends and kinks will internally damage the hose

leading to premature hose failure.

Do not drop heavy objects on hose.

A sharp impact may cause internal dam-

age to hose wire strands. Applying pres-

sure to a damaged hose may cause it to rupture.

IMPORTANT: Do not lift hydraulic equip-

ment by the hoses or swivel couplers. Use

the carrying handle or other means of safe

transport.

CAUTION: Keep hydraulic equipment

away from flames and heat. Excessive

heat will soften packings and seals, result-

ing in fluid leaks. Heat also weakens hose

materials and packings. For optimum performance do

not expose equipment to temperatures of 65°C [150°F]

or higher. Protect hoses and cylinders from weld spatter.

WARNING: Only use hydraulic cylinders

in a coupled system. Never use a cylinder

with unconnected couplers. If the cylinder be-

comes extremely overloaded, components

can fail catastrophically causing severe personal injury.

IMPORTANT: Hydraulic equipment must only

be serviced by a qualified hydraulic technician.

For repair service, contact the Authorized

ENERPAC Service Center in your area. To protect your

warranty, use only ENERPAC oil.

WARNING: Immediately replace worn or dam-

aged parts with genuine ENERPAC parts.

Standard grade parts will break causing per-

sonal injury and property damage. ENERPAC parts are

designed to fit properly and withstand high loads.