Core ColourPoint User Manual - Page 13

Browse online or download pdf User Manual for Lighting Equipment Core ColourPoint. Core ColourPoint 20 pages. Battery wireless up-light lithium

Print Page

W-DMX Pairing and Unpairing

ColourPoint units need to be manually paired with the lighting control unit equipped with a W-DMX

transmitter. This could be a lighting desk with DMX Output, or a CORE Point15/20/30 Master unit with a

W-DMX transmitter inside.

This allows a group of ColourPoint fixtures to be controlled from the lighting desk or Point15/20/30

Master using the built-in colour cycles (Inside Point15/20/30). Or set up individually selected colours

across many units at once from just one Master unit.

W-DMX Link LED

The W-DMX link status is shown by the LINK LED, this provides information on the W-DMX link. This

follows the same status indication as all Wireless Solution W-DMX products.

OFF

FLASHING

STEADY ON

UNEVEN

FLASHING

*(1) – If uneven flashing of the WDMX LED occurs as a result of a fault condition (and not because

the transmitter has no DMX signal input) then the internal WDMX card needs to be reset.

a) Turn off the unit.

b) Simply hold down the WDMX button whilst switching ON the power button.

c) Release the WDMX button after a second and the WDMX internal card should be reset. The

WDMX LED should now be extinguished.

Unpairing from all W-DMX Transmitter units



Switch on the ColourPoint.



Press and hold the



ColourPoint is now unpaired from the W-DMX transmitter.

ColourPoint User Manual V1_2

If the LED is OFF the ColourPoint is not paired with a W-DMX transmitter

If the LED is FLASHING the ColourPoint is paired with a W-DMX

transmitter, but the transmitter is switched off.

If the LED is STEADILY ILLUMINATED the ColourPoint is paired with, and ready

to receive data from a W-DMX transmitter. This is a fully paired and fully

functioning system.

If the LED is FLASHING unevenly, the ColourPoint could be paired with

a W-DMX transmitter, the transmitter is switched on, but no DMX

Input to the transmitter.

Alternatively, it could mean a fault condition on the W-DMX card inside

the ColourPoint. See *(1) for rectification below.

button until the W-DMX LINK LED is turned OFF.