Game Option Xbox Instruction Manual - Page 2

Browse online or download pdf Instruction Manual for Remote Control Game Option Xbox. Game Option Xbox 2 pages. One modded controller

Print Page

Rapid Fire

To turn Rapid Fire on, tap the Mod button on the back of the controller. When Rapid

Fire is on, the mod light will be on. When Rapid Fire is off, the mod light will be off.

1. Tap the Mod Button

2. Mod light will turn On or Off

Adjusting Rapid Fire Speed

To increase the speed of any mode, hold the right trigger and tap "down" on the D-

Pad. To decrease the speed of any mode, hold the left trigger and tap "down" on the

D-Pad. Each time you tap the D-Pad, the mod light will ﬂash.

1. Hold the left or right trigger

2. Tap down on the D-Pad

Changing Modes

You can change modes by going up a mode or by going down a mode. To go up one

mode, hold the Mod button and tap "up" on the D-Pad. To go down one mode, hold

the Mod button and tap "down" on the D-Pad. When you change modes, the mod

light will ﬂash which mode you are in. (ex. 3 ﬂashes = Mode 3)

1. Hold the Mod Button

2. Tap up or down on the D-Pad

Reset to Factory Settings

To reset your controller back to it's factory settings, hold the left trigger and tap "up"

on the D-Pad. The mod light will ﬂash 2 times, pause, and then ﬂash 2 more times.

This can be done in any mode.

1. Hold the left trigger

2. Tap up on the D-Pad

Reset a Mode to Default

To reset the mode you are in to it's default settings, hold the right trigger and tap "up"

on the D-Pad. The mod light will ﬂash 2 times, pause, and then ﬂash 2 more times.

1. Hold the right trigger

2. Tap up on the D-Pad

Adjusting Burst Fire Length (Complete All Steps)

You can adjust the number of shots in a burst (3 shot burst, 4 shot burst, etc.). To

adjust the burst length, ﬁrst make sure you're in burst mode (Mode 10). Then, hold

both the right trigger and left trigger and tap the Mod button. The mod light will ﬂash

2 times. This signals you are in programming mode.

1. Hold the left and right triggers

2. Tap the Mod button

Once you're in programming mode, hold the right trigger and tap the Mod button to

increase the burst length by 1 shot. Hold the left trigger and tap the Mod button to

decrease the burst length by one shot. The controller is set to a 3-shot burst by

default.

1. Hold the left or right trigger

2. Tap the Mod button

Once your burst length is all set, you'll need to save the settings. To save the

settings, hold both the right trigger and left trigger and tap the Mod button. The mod

light will ﬂash 3 times. This signals your settings have been saved.

1. Hold the left and right triggers

2. Tap the Mod button