Jafar 3510 Operating Manual - Page 6
Browse online or download pdf Operating Manual for Control Unit Jafar 3510. Jafar 3510 9 pages. Resilient seated gate valves with iso fitting for pe pipe
Print Page
4. STORAGE & TRANSPORT
The products are packed on EURO pallets (1200x800 mm) or in custom containers, as applicable. Store the valves
in clean indoor rooms without bacteriological or chemical contaminants and at a room temperature between -20°C
and 70°C. Protect the paint coat and rubber parts from prolonged exposure to UV radiation. The filters should be
protected against mechanical damage.
Protect the rubber parts from compression by keeping the gate valve wedge closure halfway open. Secure the
products against shifting during shipping and handling.
5. INSTALLATION
The Type 3500 and 3510 gate valves with ISO fitting for PE pipe can be installed in underground or surface
pipelines both in horizontal or vertical orientation. The listed products are suitable for joining with PE pipes of
pipelines with size equal to that of the valve ISO fittings. Note that the system must not expose the (gate) valve
to bending or tensile stress from loading with the weight of unsupported pipeline sections. Assemble with
consideration to pressure and temperature compensation of the pipeline. The gate valve assembled and adjusted
by the manufacturer is ready for installation. Any dismantling of the valve components may result in loss of
tightness.
Before attempting to install the valve, check the technical and commercial documents delivered with the product
to verify that your media and pipeline operating parameters comply with the manufacturer's declaration. Any
change in the operating conditions must be consulted with the manufacturer beforehand.
Before attempting to assemble the valve, remove the main bore plugs, check the inner surfaces of the valve and
thoroughly flush with water, if necessary. Install the gate valve on a base or a support adequate to the size and
weight of the valve, to prevent strain of the piping with the valve. The gate valve location must prevent exposure
to freezing of the medium flowing through the gate valve. It is necessary to equip the unit with a flexible or rigid
housing, and street box founded on a base slab.
Installation procedure of pipe in gate valve:
L = INSERTION DEPTH – apply lubricating compound on pipe
OPERATING MANUAL
10-2022
6/9