Maiwe MIEN2204-2M User Manual - Page 13

Browse online or download pdf User Manual for Switch Maiwe MIEN2204-2M. Maiwe MIEN2204-2M 17 pages. Unmanaged industrial ethernet switch

Print Page

MIEN2204 Series Unmanaged Industrial Ethernet Switch

The terminal equipment interface provided by MIEN2204 series switches

is a 10Base-T / 100Base-TX Ethernet RJ45 interface, which uses a DC

network cable to connect to the terminal equipment and a crossover network

cable to connect to the network equipment.

Connecting Power

MIEN2204 series switches use power according to the instructions on the

product label. When all other cables are connected, the power can be

connected

3.3. Fiber Interface Connecting

MIEN2204 series switches provide 100Base-FX full-duplex single-mode or

multimode fiber interfaces. The type of optical fiber interface can choose SC /

ST / FC according to demand.

Attention

This switch uses a laser to transmit signals on fiber optic cables. The

laser meets the requirements of Class 1 laser products, and normal

operation is not harmful to the eyes. However, when the device is powered

on, do not look directly at the optical transmission port and the end face of

the fiber terminator.

The steps to connect pluggable fiber optic modules are as follows:

Remove and keep the rubber sleeve of the SC / ST / FC port. When not

in use, put on a rubber sleeve to protect the fiber optic terminator

Check whether the fiber terminator is clean. Lightly moisten a clean

paper towel or cotton ball and gently wipe the cable plug. A dirty fiber

terminator will reduce the quality of the optical transmission and affect the port

performance

Connect one end of the optical cable to the optical fiber interface and the

other end to the optical fiber interface of another device

After the connection is completed, please check the LINK / ACT indicator

of the corresponding optical port on the front panel.

The cable layout must meet the following conditions:

Check whether the specifications, models and quantities of all cables are

in compliance with the construction drawing design and contract requirements

before laying out the cables

Before laying the cable, check whether the cable is damaged, whether

there are factory records and quality assurance certificates that prove its

quality

- 9 -