Maiwe MIEN2206-2F User Manual - Page 2
Browse online or download pdf User Manual for Switch Maiwe MIEN2206-2F. Maiwe MIEN2206-2F 5 pages. Industrial ethernet switch
Print Page
Interface description
Unit:mm
35
35
RJ45 port
Fiber port
RJ45 port
Item
Crimp one end of the grounding screw with the cold-pressed
Ground screw
terminal. The other end of the grounding wire is connected to the
ground, and the grounding wire is not less than 2.5mm2
Support Dual DC9-60V.
Power interface
Support single power input AC85-264V or DC110-370V.
Supports automatic MDI/MDI-X connection. You can connect the switch
Ethernet RJ45 port
to terminal devices, servers, hubs, or other switches.
The 100M fiber port is a 100Base-FX full-duplex single-mode or
multi-mode fiber connector, which support single-fiber or dual- fiber
Fiber port
connectors, and the connector can be SC, ST or FC. The optical
fiber connectors must be used in pairs (TX and RX are a pair).
Din-rail kit
To fix the switch.
100
140
Power supply
Description
The indicator description of the switch is shown in the following table.
Indicator lights
Ground screw
PWR1/PWR2
RUN
LINK
Each RJ45 port has two indicator lights, the yellow light is the port plastic rate indicator, the
green light is the port connection status indicator.
10/100M
(Yellow)
Link/Act
(Green)
Status
System Status LED
On
The power is connected and operating normally
The power is not connected or the system is not operating
Off
normally
The system is operating normally (some models are always
Flashing
on to indicate normally)
Off
The system is not working properly
Fiber Port Status LED
On
The port has established a valid network connection
Flashing
There is network activity on the port
Off
No valid network connection is established on the port
RJ45 Port Status LED
On
100M working state (namely 100Base-TX)
Off
10M working status (namely 10Base-T)
On
The port has established a valid network connection
Flashing
There is network activity on the port
Off
No valid network connection is established on the port
Definition