Gree 13-06091 Owner's Manual - Page 4
Browse online or download pdf Owner's Manual for Dehumidifier Gree 13-06091. Gree 13-06091 11 pages.
Print PageAbout the controls on the dehumidifier.
4 hour or 2 hour
delay on/off
High，Mid and L ow fan
indicator lights
indicator lights
Controls
NOTE: When the bucket is full or removed,
the controls cannot be set.
1
ON/OFF Pad
Press to turn the dehumidifier on and off.
2
FILTER Pad
After 250 hours of operation, the Clean
the Filter indicator light will glow to
remind you to clean the filter. Remove
the filter and clean it.
Press to turn off the Clean the Filter
light. See the Care and Cleaning section.
Humidity Set Control Pads
3
The humidity level can be set within a
range of 80% RH (Relative Humidity) to
35% RH (Relative Humidity) in 5%
reduce or at CO for continuous operation.
NOTE: If CO (Continuous) is selected,
the dehumidifier will operate continu-
ously at its maximum dehumidification
settings if attached to a hose to drain or
until the bucket is full.
For drier air,press the - pad and setto a
lower percent value (%). For damper air,
press the + pad and set to a higher per-
cent value (%).
When you first use the dehumidifier, set
Other Features
BUCKET FULL Light
Glows when the bucket is ready to be
emptied, or when the bucket is removed
or not replaced in the proper position.
Alarm
If the bucket is full or missing for more
than three minutes, an alarm will sound
for about 10 seconds to remind you to
empty and replace the bucket.
Auto Shut Off
The Water Level Control Switch shuts off
the dehumidifier when the bucket is full,
or when
Bucket full light indicates
bucket needs to be emptied
the humidity control to 45% or 50%. Allow
at least 24 hours for the dehumidifier to
achieve the humidity level. If you still have
damper air than desired, set the humidity
level to a lower setting or select Continuous
for maximum dehumidification.
This unit has 3-min lag due to the device
for protecting circuit .In order to prolong
the compressor's working life, the compres-
sor will not start until the unit has run for 3
minutes.
Display
4
Shows the set % humidity level while set-
ting, then shows the actual (+/– 5% accura-
cy) room % humidity level.
FAN SPEED Pad
5
Controls the fan speed.
Press to select High or Mid or Low fan
speed.
Set the fan control to High for maximum
moisture removal. When the humidity has
been reduced and quiet operation is pre-
ferred, set the fan control to Mid or Low.
6
TIMER Pad
If unit is turned on and running in timer
mode for 2hr or 4hr,can turn off the unit.
When unit stand by and running in timer
mode for 2hr or 4hr can turn on the unit.
the bucket is removed or not replaced in
the proper position.
Auto Defrost
When frost builds up on the evaporator
coils, the compressor will cycle off and
the fan will continue to run until the frost
disappears.
Power Outage
In the case of a power outage or interrup-
tion, the unit will automatically re-start,
in the settings last used, after the power
is restored.
3
Continuous operation on
indicator light
Power On
indicator light
Clean the Filter
indicator light