Majacraft Pioneer Aassembly Instructions - Page 8

Browse online or download pdf Aassembly Instructions for Spinning Wheels Majacraft Pioneer. Majacraft Pioneer 11 pages.

Print Page

8. Conrods to Pedals

Required:

2 - Gold 25mm (1") screws (in the hardware bag)

Posidrive screwdriver

The green joiners have already been put in place in the black fibreglass conrods. Place the wheel in

front of you so the crank and drive wheel are facing you.

We will start with the pedal on your left hand side. Select the conrod that is CLOSEST to YOU. It is

on the end of the curved arm and is attached to the crank assembly with the special right angle

rod end connector. Push the green joiner into the hole at the end of the pedal until it protrudes

by about 5mm. Check the alignment of the rod end in the crank assembly as shown in the images

below. You may need to twist the green joiner in the pedal to correct the alignment. When the rod

end is aligned correctly, screw the 25mm gold screw in the pedal into place.

Now work on the pedal on your right. Obviously there will only be one available conrod now. The

one that is CLOSEST to the DRIVE WHEEL. Push the green joiner through the hole in the pedal end

into the right hand pedal. It should protrude through the bottom of the pedal about 5mm. Check

the alignment of the inner rod end in the crank assembly. When the rod end is aligned correctly -

parallel with the face of the drive wheel - screw the 25mm screw back into place. The screw should

only be tightened until the head just touches the side of the pedal. DO NOT OVERTIGHTEN!

When the three screws are all in place, you can finish

tightening them up.

CORRECT

INCORRECT

majacraft