Airfield 95A251 Assembly Manual - Page 4

Browse online or download pdf Assembly Manual for Toy Airfield 95A251. Airfield 95A251 8 pages.

Print Page

* Very Soft – Provides initial slow 1.5 sec ramp-up from start to full rpm intended to protect delicate

gears from stripping under instant load. This setting is recommended for either fixed wing models

equipped with gearboxes and / or helicopters.

* Soft Acceleration- Provides initial slow 1 sec ramp-up from start to full rpm. This setting is

recommended for either fixed wing models equipped with gearboxes and or helicopters.

* Start Acceleration – Provides quick acceleration start ups with a linear throttle response. This is

recommended for fixed wing models fitted with direct drive setups.

7.Active RPM Control (Heli Governor mode)

* RPM Control OFF

* First Range: There will be a 5-second delay from start to full rpm, but if the throttle is cutoff after

starting, then the next start will be as normal start.

* Second Range: There will be a 15-second delay from start to full rpm, but if the throttle is cutoff after

starting, then the next start will be as normal start.

Note: Once the Governor Mode is enabled, the ESC's Brake and Low Voltage Cutoff Type settings will

automatically be reset to No Brake and Reduce Power respectively regardless of what settings they were

previously set.

8.Motor Rotation: Forward/ Reverse

In most cases motor rotation is usually reversed by swapping two motor wires. However, in cases where

the motor cables have been directly soldered the ESC cables, motor rotation can be reversed by

changing the value of setting on the ESC.

9.Switching Frequency : 8kHz/16kHz

* 8kHz – Sets ESC switching frequency for 2 pole motors, e.g. in-runners.

* 16kHz – Sets ESC switching frequency for motors with more than 2 poles, e.g. out-runners.

Although 16kHz is more efficient with our Thrust motors, the setup

default is 8kHz due to the higher RF noises caused at 16kHz.

10.Low Voltage Cutoff Type : Reduce Power / Hard cutoff

* Reduce Power – ESC reduces motor power when the pre-set Low Voltage Protection Threshold value

is reached. (recommended)

* Hard Cutoff – ESC instantly cuts motor power when the pre-set Low Voltage Protection Threshold

value is reached.

Programming Mode Audible Tones

Throttle Calibration

(within the first 4 Sec )●● ●● ●● ●●

Brake

_ * _ * _ *

Battery type

～～～～

～～

Low Voltage Cutoff Threshold

*_ _* *_ _* *_ _* *_ _*

*_ _ _* *_ _ _* *_ _ _* *_ _ _*

*_ _ _ _* *_ _ _ _* *_ _ _ _* *_ _ _ _*

Restore Factory Setup Defaults

— — — —

Timing Setup

– – – –

–– –– –– ––

––– ––– ––– –––

Soft Acceleration Start Ups

ESC Functions

_ *

Brake On /Off

NiCad

LiPo

～～

Low2.8V/50%

Medium3.0V/60%

High3.2V/65%

Restore

Automatic (7-30°)

Low (7-22°)

High (22-30°)