deBont Vidur Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Amplifier deBont Vidur. deBont Vidur 10 pages.

Print Page

█ Voltage selector

The Vidur can be used in countries with mains voltages ranging from 110VAC to 120VAC or

from 220VAC to 240VAC. Choose the voltage closest to the actual mains voltage by turning

the selector with a small screwdriver until it clicks into place. Failure to do so will either cause

the preamp to not work properly, or cause serious damage to the inside electronics.

The Vidur is fed by a IEC 60320 C13 plug, better known as a computer plug. Please make

sure the power cord is undamaged and of proper quality.

Use this switch to turn the

preamp on or off.

Note: There's no standby

switch as seen on most

other tube amplifiers. The

Vidur will take care of all processes normally associated with standby switches automatically.

Note: After power on, the preamp will enter a startup procedure. The three LED's (mute, fx

loop and EQ) will indicate the progress. After the startup, the EQ LED will blink three times

with the current selectable sound signature setting.

This fuse cuts power to the entire amplifier in case of a serious electrical fault.

█ Replacing a fuse

Turn the preamp off, unplug the power cord and let the remaining energy drain for at least 20

minutes before checking and/or replacing any of the fuses. Always replace with a fuse of the

same type and rating as stated on the back of the preamp next to the fuse holder.

Note: Fuses usually blow for a good reason. Please consult a qualified technician when

replacement is necessary.

deBont Amps Vidur Tube Preamplifier Owner's Manual