Adexa PBF 88/128 Manual - Page 5

Browse online or download pdf Manual for Commercial Food Equipment Adexa PBF 88/128. Adexa PBF 88/128 8 pages. Bakery & pastry ovens

Print Page

UPPER FRONT, UPPER REAR AND BOTTOM SET DISPLAY, LEDS AND ADJUSTMENT KEYS: How long

will the heating circuit goes, sets up with the arrow keys and the value is seen at the indicators related with

resistance. Resistance's LED lights are active as long as related resistance is enabled. The display shows

when no resistance is active,

times more than the value on the display, in the remaining time the resistances are disabled. Total control time

(period) is 30 seconds. For example if the value entered as 4, the resistance will be enable 12 seconds LED

will go on, for 18 seconds resistance will be disabled and LED will go off.

ON-OFF KEYS AND LEDS: When the device is energized, key LED lights up red. When the

key is pressed, the device is energized. Key LED lights up green and all indicators lights up

also. Pressing the button again deletes indicators and key LEDs lights up red.

TURBO BUTTON AND LED:

activated. tans Indicators show "10" and LED turns on. When the key is pressed again the

LED turns off. The preset resistance levels are seen in the display and the oven will continue

to work according to the proportional value. When the START button is pressed, the turbo is

activated automatically.

INDICATORS AND KEY TRANSACTIONS

TEMPERATURE

DECREASE KEYS: The set temperature indicates the set

value. Setpoint adjustment can be done by increasing,

decreasing keys at the range of 30ºC and 350ºC . If the

increase or decrease buttons are held down for 3 secons, the

value increases or decreases very quickly. The values shown

in displey will be automatically stored.

In the faults related "Er.x" values are also seen.

TIME INDICATORS AND INCREASE, DECREASE KEYS :

The time display shows the remaining time. Time setting can

be done by incraseing, decreasing keys between the range 1

and 60 minutes. If the increase or decrease buttons are held

down for 3 secons, the value increases or decreases very

quickly. The values shown in displey will be automatically

stored.

Time LED, flashes once per second when the time counting

begins.

"10"

is seen the resistance is constantly active. Resistances stay enabled 3

SET

INDICATORS

Key LED lights up when is pressed, all resistances are

AND

INCREASE,

"0"

Sayfa 5