IKEA BEKANT 090.225.40 Instructions Manual - Page 5
Browse online or download pdf Instructions Manual for Indoor Furnishing IKEA BEKANT 090.225.40. IKEA BEKANT 090.225.40 16 pages.
Print Page
Advice and instructions
for BEKANT sit/stand desk.
Sound level: lower than 55 dB(A)
Height setting interval:
EU-version: 64-125 cm
NA-version: 57,4-122,4 cm/22,6-48,2 inch
Maximum load: 70 kg/154 lbs
Temperature interval at usage:
+5 up to +40°C / 41 up to 104°F
Temperature interval at storage:
-10 up to +50°C / 14 up to 122°F
Humidity:
20% up to 80% at +30°C / 86°F.
Power supply unit:
DC 25-35V, 240W
100-240VAC, 4A/2A
Manufacturer: ROL ERGO
Model: ASW0579-2902002W
Duty Cycle: 1 min on / 9 min off.
This appliance shall only be used
together with the included power
supply unit.
Every person who is responsible for this
table at installation or employment of
the table in daily use or in service and
repair work should carefully read these
instructions. Keep these instructions
close to your sit/stand table.
Installation instructions
• The table is assembled according to
separate assembly instructions.
• Connect the cable from one leg to the
other. Connect the hand control to
one of the leg and the power-supply to
the other leg. The cables to the legs,
hand control and power supply should
be placed in the accompanying net.
Place the electrical cables so that they
do not get damaged, see assembly
instruction.
• Connect the electrical cable to a wall
socket.
NB! The electrical cable must have full
mobility.
• Insert the safety key in the socket on
the hand control.
• The table is now ready for use. The
motors stop automatically when the
table reaches its lowest and highest
position respectively.
Usage of the table
• The table shall only be used as a
working table with the possibility
to continuously adjust working
height between sitting and standing
position. The table shall only be used
indoors and in dry premises (office
environment or similar).
• The table must not be overloaded -
maximum load is 70 kg/154 lbs. The
motors may be run continuously for
maximum 1 minutes. Afterward, the
motors must stand by for approx.
9 minutes before they can be used
again.
Follow these instructions when
adjusting table height:
1. Insert the safety key in the socket on
the hand control.
2. Make sure no objects are in the way
of the table adjusting height freely.
3. In order to run the table up/
down, press the manoeuvre button
with an arrow pointing up and down
respectively.
5