Bristan HOU 1HBF C Installation Instructions & User Manual - Page 2

Browse online or download pdf Installation Instructions & User Manual for Plumbing Product Bristan HOU 1HBF C. Bristan HOU 1HBF C 5 pages.

Print Page
Important
The images shown are for
illustrative purposes only.
The tap you have purchased may
look different to those pictured in
this booklet but will follow the same
installation steps.
Your contents page will be specific
to your product.
If you find your product or any of
its components differ from those
shown on the contents page, please
contact our customer support.
2
Screw in the fixing kit
rod(s) into the base of the
tap with a screwdriver
Screw in the
flexible tails by
hand only.
DO NOT
OVERTIGHTEN
Your model may come
with a plinth and will
either be included
pre-attached or loose in
the box*
3
Thread the flexible
tails and fixing kit rods
through the bath hole
4
If the hole is not
large enough for
both tail ends to
fit through,
screw one of the
tails in from
begin tightening the nut up the rod
underneath the
bath

Installation

1
Depending on the model, the tap will utilise 1 or 2
fixing kit rods. Refer to your contents page
1 Fixing Rod
Flexi Tails
Holes
Fixing
Rod Hole
2*
From underneath the bath,
slide the rubber gasket and
metal c plate along the
fixing rod(s) with the
gasket sitting on top of
the c plate
Align the gasket and c plate, then
towards the bath until secure
Look underneath the
tap body to observe
fixing kit rod(s) and
tail inlet positions
2 Fixing Rods
Fixing
Rod Hole
Fixing
Rod Hole
Flexi Tails
Holes
If required, thread
the flexible tails
and fixing kit rods
through the plinth
and rubber seal
(if loose) and align
with tap body
Take note of any grub
screw holes on the
underside of the tap and
align them correctly to
the holes on the plinth