AIRFLO AFS140 Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Kitchen Appliances AIRFLO AFS140. AIRFLO AFS140 7 pages. Hand held steamer

Print Page

Connecting extension hose

1. Align female end of Extension Hose with Steam Nozzle (FIGURE 4). Guide key on Extension Hose

should line up with key slot on base of Steam Nozzle.

2. Slide Extension Hose onto Steam Nozzle, being sure to push it on as far as it will go. Rotate

Extension Hose clockwise, turning it until you feel it "lock" into place and it will move no further

(FIGURE 4)

FIGURE 4

Align Jet Nozzle with male end of Extension Hose (FIGURE 5). Guide key on Jet Nozzle should

line up with key slot on base of Extension Hose nozzle.

Slide Jet Nozzle onto Extension Hose, being sure to push it on as far as it will go. Rotate Jet

Nozzle clockwise, turning it until you feel it "lock" into place and it will move no further

(FIGURE 5).

GUIDE KEYS

KEY SLOTS

FIGURE 5

Filling boiler

1. Place Hand Held Steamer on a ﬂat, level surface.

2. Make sure power cord is unplugged from electrical outlet.

3. Cautiously remove Boiler Cap by unscrewing it in a counter-clockwise direction, and lift it off.

CAUTION: Refer to reﬁlling procedure below for additional safety precautions that must be taken

when reﬁlling the unit after it has been in use.

4. Boiler should always be emptied after each use. If it was not emptied after the previous use,

empty it before using. This will make it easier to ﬁll with the correct amount of water

5. Fill included Measuring Cup with 6 oz. (180 ml.) of water.

NOTE: In order to extend the life of your Hand Held Steamer and keep it functioning at its

maximum potential, it is highly recommended that distilled or de-mineralized water be used in

Boiler.

6. Carefully pour water from Measuring Cup into Boiler through ﬁll hole.

NOTE: Do not exceed the Boiler's maximum capacity of 6 oz. (180 ml.). This will ensure a

better ﬂow of steam with minimal dripping water.

7. Replace Boiler Cap, screwing it in a clockwise direction to tighten. Make sure it is screwed on

securely to prevent hot water or steam from escaping.

Refilling boiler

If unit has been in use, always use the following safety precautions before removing the

Boiler cap to add water:

Allow unit to cool for 5-10 minutes.

Press and hold Steam Trigger to release all remaining steam.

pressurized inside Boiler for up to an hour after use.

WARNING: Failure to follow these precautions may result in burns from escaping steam when

Steam can remain