Centrometal Bio-Tec 25 Technical Manual - Page 15
Browse online or download pdf Technical Manual for Boiler Centrometal Bio-Tec 25. Centrometal Bio-Tec 25 17 pages.
Print Page
- 1. Technical Data
- 2. Delivery Package
- 3. Additional Equipment
- 4. Cleaning and Maintenance of the Boiler
- 5. Connection to the Chimney
- 6. Boiler Use
- 7. Connection to the Central Heating System
- 8. Boiler Start up
- 9. Boiler Thermal Protection
- 10. Thermal Fuse
- 11. Electric Connection
- 12. Boiler Regulation
Boiler regulation
7.0. BOILER REGULATION
2
10 11
3
4
5
1
-
Main switch (power supply switch) has the function to turn on / off the
regulator.
2
- LED display shows the measured temperatures, their ordinary number,
number or parameter value as well as the regulator functioning mode signal.
3
- Indication "START" (LED diode) shows the regulator functioning mode
(ignition/operation).
4
- "START"-button.
5
- "P"-button.
6
- "+"-button.
7
- "-/STOP"-button.
8
- "GLOW"-button.
- Indication "GLOW" (LED diode). Indicates the active functioning of the burning
9
process with glow keeping. This burning process mode can be turned on/off by
pushing the button 8.
10
- Indication "FUEL" (LED diode) indicates that after the period of the boiler
warming up has run out, the flue gases temperature is under the setup level for
burning with or without glow keeping. It is not recommended to open the boiler's
door while the indication ''FUEL'' is NOT on.
11
- Indication "FAN" (LED diode) indicates that the fan is turned on/off.
- Indication "ERROR" (LED diode) indicates that the error appeared during the
12
boiler functioning.
13
- Indication "PUMP 1" (LED diode) indicates that the relay for the P1 supply is
turned on/off.
14
- Indication "PUMP 2" (LED diode) indicates that the relay for the P2 supply is
turned on/off.
15
- Indication "PUMP 3" (LED diode) indicates that the sanitary water pump is turned
on/off.
18
12 13 14 15
6
7
8
9
1
Technical manual Bio-Tec
Scheme 3. -
Thermal protection in an closed heating system
5
4
6
7
1
Sewage
outlet
2
3
6.0.
STEERING OF THE BOILER
The boiler is steered by means of the electronic regulator (digital boiler regulation),
which is built into the boiler on its upper side and has an steering and protecting
function. The functions of the boiler regulations are described in the Point 7.0 and in
Tecnical manual "Digital boiler regulation Bio-Tec".
Technical manual Bio-Tec
Thermal safety valve, steering of the boiler
1 - Heat exchanger connection
2 - Connecting point for the thermal safety
valve sensor
3 - Heat exchanger connection
4 - Thermal safety valve connection
(cold water inlet HV)
5 - Connecting point of the thermal safety valve
(to the boiler)
6 - Thermal safety valve-sensor
7 - Thermal safety valve
Safety air
vent group
bar
Inlet
1
2
3
Filling/Draining
Outlet
Heat
exchanger
(factory
built in)
15