Gamma 6002 Owner's Manual - Page 13

Browse online or download pdf Owner's Manual for Stringing Machines Gamma 6002. Gamma 6002 20 pages.

Print Page

STRINGING THE FRAME

Pulling Tension

Wrap the loose section of string once around

the DIABLO and insert the string between the

diamoind dust coated string gripper plates.

Pull the string perpendicular to the gripper

plates while slowly rotating the tensioner

crank clockwise until the brake lever pops out

of the latching block. The string is now

tensioned and can be clamped in place with

the remaining fixed clamp.

Repeat the above steps until all main strings

are installed. Tie off ends of main strings as

per racquet manufacturers recommenda-

tions.

Clamping the First Main String

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand.

Secure one of the strings using a string

clamp.

Weave the cross strings over and under the

main strings being careful to alternate the

weave direction of each consecutive cross

string so as to be opposite of the previously

installed cross string.

Once the final cross string is tensioned and

clamped, tie off at the appropriate hole speci-

fied by the racquet manufacturer.