Gamma 6004 Owner's Manual - Page 17

Browse online or download pdf Owner's Manual for Stringing Machines Gamma 6004. Gamma 6004 20 pages. 6 point mounting
Also for Gamma 6004: Owner's Manual (20 pages), Owner's Manual (20 pages), Owner's Manual (19 pages)

Print Page

MAINTENANCE and ADJUSTMENTS

Turntable Brake Pad Replacement

Loosen the four set screws located at the top of the

turntable tube until the turntable and turntable flanged

pin can be lifted from the support tube.

Insert the 2.5 mm L-shaped wrench into the flat head

screw located on the inner side of the brake pad and the

end of the brake lever bolt. While holding the locking

lever bolt, turn the head of the screw counterclockwise

with the wrench to loosen the brake pad. Carefully

remove the turntable pad screw.

Pull the brake pad toward the center of the tube to

remove the pad from the end of the brake lever. Lift the

brake pad from the tube.

Place the new brake pad into the turntable tube. Insert

the end of the brake lever bolt into the hole in the of the

brake pad until the brake pad rests on the shoulder of the

bolt.

Insert the flat head screw into the end of the brake lever

bolt from the inner side of the brake pad. While holding

the head of the screw with the 2.5MM L-shaped wrench,

turn the lever bolt to secure the brake pad against the

shoulder of the lever bolt and set the head of the screw

below the brake pad surface. Turn the lever to retract

the pad until it sets against the inner surface of the

turntable tube which provides clearance for installation

of the turntable. Re-install the turntable and tighten the

4 set screws to secure the turntable to the turntable

tube.