Gamma 6004 Owner's Manual - Page 16

Browse online or download pdf Owner's Manual for Stringing Machines Gamma 6004. Gamma 6004 19 pages. 6 point mounting
Also for Gamma 6004: Owner's Manual (20 pages), Owner's Manual (20 pages), Owner's Manual (20 pages)

Print Page

MAINTENANCE & ADJUSTMENTS

table tube which provides clearance for installation of the turntable. Re-install the turntable and

tighten the 4 set screws to secure the turntable to the turntable tube.

Turntable Brake Pad Replacement

Loosen the four set screws located at the top

of the turntable tube until the turntable and

turntable flanged pin can be lifted from the

support tube.

Insert the 2.5 mm L-shaped wrench into the

flat head screw located on the inner side of

the brake pad and the end of the brake lever

bolt. While holding the locking lever bolt, turn

the head of the screw counterclockwise with

the wrench to loosen the brake pad. Care-

fully remove the turntable pad screw.

Pull the brake pad toward the center of the

tube to remove the pad from the end of the

brake lever. Lift the brake pad from the tube.

Place the new brake pad into the turntable

tube. Insert the end of the brake lever bolt

into the hole in the of the brake pad until the

brake pad rests on the shoulder of the bolt.

Insert the flat head screw into the end of the

brake lever bolt from the inner side of the

brake pad. While holding the head of the

screw with the 2.5MM L-shaped wrench,

turn the lever bolt to secure the brake pad

against the shoulder of the lever bolt and set

the head of the screw below the brake pad

surface. Turn the lever to retract the pad until

it sets against the inner surface of the turn-