Gamma Progression 600FC Owner's Manual - Page 4
Browse online or download pdf Owner's Manual for Stringing Machines Gamma Progression 600FC. Gamma Progression 600FC 15 pages.
Print Page
ASSEMBLY INSTRUCTIONS
Engaging the Drop Weight Bar Stop
The stringing machine is shipped with the
drop weight bar in the horizontal position. To
prevent racquet damage during stringing,
the bar stop must be engaged.
Remove the machine base from the shipping
carton being careful to avoid lifting by the
plastic cover.
Hold the drop weight bar in the vertical
position as shown while turning the stop
screw clockwise with the supplied 5mm hex
wrench.
Installing the Turntable
The turntable is located under the foam
packing in the bottom of the shipping carton.
Insert the center post of the turntable into
the bushing of the stringing machine base.
Installing the Frame Support Posts
The GAMMA 600 support post assemblies
are precision aligned at the factory and are
marked for proper installation on the turn-
table.
Install the support post with the dot on its
base to an identical dot on the turntable. Align
the threaded hole in the bottom of the frame
support post with the slot in the turntable.
Screw the lever lock bolt with washer into
the bottom of the support post and tighten
gently.Position the washer the rounded side
toward the turntable.
Repeat procedure on the opposite side of
the turntable
3