Gamma Progression ES II Owner's Manual - Page 4

Browse online or download pdf Owner's Manual for Stringing Machines Gamma Progression ES II. Gamma Progression ES II 16 pages.

Print Page

ASSEMBLY INSTRUCTIONS

Turntable Installation

Insert the turntable center post into the bushing of the stringing

machine base.

Frame Support Post Installation

The ESII support post assemblies are precision aligned at the

factory and are marked for proper installation on the turntable.

Install the support post with the dot on its base to an identical dot

on the turntable. Align the threaded hole in the bottom of the frame

support post with the slot in the turntable. Screw the lever lock bolt

with washer into the bottom of the support post and tighten

gently.Position the washer the rounded edge toward the turn-

table. Repeat procedure on the opposite side of the turntable.

NOTE: 2 pcs. of M10 cap screws (#170) are provided with the

machine in the event the lever lock bolts become inconvenient.

Simply install the M10 screws in place of the lever lock bolts and

tighten with the wrench provided.

Clamp Head Installation

The post of the string clamp head and tube of the string clamp

base are treated with grease to provide protection against corro-

sion during shipping. Remove any excessive grease with a clean

cloth prior to use. The post and tube may also be cleaned with

isopropyl alcohol. After this type of thorough cleaning, the post

and tube should be treated with a light coating of machine oil to

protect the surfaces against corrosion and to ensure smooth

operation.