Gamma X-Stringer Owner's Manual - Page 5
Browse online or download pdf Owner's Manual for Stringing Machines Gamma X-Stringer. Gamma X-Stringer 19 pages.
Print Page
ASSEMBLY INSTRUCTIONS
Travel Stop
Support Post Installation (cont'd)
Place the support post onto the central slot
of the turntable. With your fingers placed
through the large hole in the underside of the
turntable, press the mounting plate against
the inside top surface of the turntable while
aligning the hole in the support post with the
hole in the mounting plate and fix them with
the mounting bolt. Repeat procedure on to
attach the support post on the opposite side
of the turntable.
Installing the Tensioner
Remove the button head screw and washer
located at the end of the tensioner bar with
the 3 mm hex wrench provided. Slide the
tensioner onto the bar, being careful to align
the bar with all of the bearings and the drive
gear with the gear track. Replace the screw
and washer into the end of the tensioner bar.
Note: The tensioner bar is equipped with a
tensioner travel stop to limit travel of the
tensioner along the bar.
Tensioner Travel Stop
The tensioner bar is equipped with a tensioner
travel stop to limit travel of the tensioner
along the bar and prevent contact between
the tensioner and the racquet mounting sys-
tem while stringing. The travel stop is lo-
cated about midpoint along the tensioner bar
below the gear track.
To disengage the stop, pull and hold the
knob, rotate 90 degrees and release. To
engage the stop, repeat the above proce-
dure until the travel stop pin protrudes be-
yond the opposite surface of the tensioner
bar.
4