Gamma Sports 602FC Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Stringing Machines Gamma Sports 602FC. Gamma Sports 602FC 9 pages.

Print Page

STRINGING THE FRAME

Weaving the Cross Strings

Weave the cross strings over and under the

main strings being careful to alternate the

weave direction of each consecutive cross

string so as to be opposite of the previously

installed cross string.

Once the ﬁ nal cross string is tensioned and

clamped, tie off at the appropriate hole speci-

ﬁ ed by the racquet manufacturer.

ADDITIONAL FEATURES

Badminton Shoulder Support Pad

Installation

Slide the badminton shoulder support cover

over the shoulder supports. There is no need

to remove the tennis shoulder supports.

Note: An optional badminton frame support

for the head of the racquet is available.

STRINGING THE FRAME

for increased friction between the clamps and the string to allow for reduced clamping pres-

sure while securing and holding the string under tension.

Note: If the string slips in the string clamp while tensioning, adjust the gap between the clamp

jaws as per the instructions on page 12.

Setting Tension

To set the stringing tension, loosen the

locking knob on the side of the drop weight.

Slide the weight in the appropriate direction

until the face closest to the string gripper is

indexed with the desired tension mark on

the tension bar.

The drop weight is of a two piece design.

When assembled, it will accommodate ten-

sions from 20 to 90 lbs. For tensions from 8

to 20 lbs., remove the 5mm bolt on the face of

the drop weight, and use the smaller portion

of the weight as described above.

Note: Tensions above 77lbs. require removal

of the drop weight bar end cap.

Fixed Clamp Operation

The ﬁ xed clamps are of a dual action design.

The string clamp and the clamp base operate

independently of one another.

To clamp a string, lift the clamp head and

place the string between the jaws. Depress

the clamp head lever to secure the string.

The clamping pressure applied to the string

should be adjusted to provide sufﬁ cient pres-

sure to secure the string when subjected to

the desired pulling tension.

The diamond coated gripper plates provide