Green Brook DPL03A Instructions

Browse online or download pdf Instructions for Accessories Green Brook DPL03A. Green Brook DPL03A 2 pages.

Print Page

These products should be installed by a competent person

and in accordance with the current IET Wiring Regulations.

Bell Pushes -

If you have bought a bell push only please go straight to step 'Wiring Your Bell Push' in these

instructions.

(DPL03A & DPL04A must be used with a bell transformer)

This doorchime has a traditional ding-dong sound and is easily fitted for use with

any bell push.

• Bell wire required

• Bell push required

• Fixing screws included

• Requires 3 x C cell LR14 batteries (not included)

An ornate bell push can be used if preferred. (For illuminating bell pushes a

transformer must also be used - GreenBrook model number DAT01A)

1. Unclip top cover.

2. Thread bell wire from the back of the base and through the large opening to

the left of the keyhole slot.

3. Insert either one of the stripped ends to terminal A and the other

to terminal C, ensuring the terminal screws are tightened securely afterwards.

Do not use terminals marked B and D.

4. Position the base on the wall vertically, away from opening doors, with the

battery compartment at the bottom. Ensure that it is less than 5 metres

away from the bell push.

5. Use one of the screws and wall fixings to hang the base on the wall via the

top keyhole slot. Adjust the screw for a flush fit if required.

6. Insert 3 x C cell batteries as per markings on the inside of the case.

Instructions for Wired Doorchimes & Bell Pushes

Model Nos:

If in doubt, consult a qualified electrician.

PLEASE READ THE FOLLOWING INSTRUCTIONS

FULLY BEFORE ATTEMPTING INSTALLATION.

PREPARING BELL WIRE

WIRING YOUR DOORCHIME

DH020A (Galaxy Chime)

DH021A (Tubular Chime)

Bell Pushes:-

DP010A

Black Bell Push

DP020A

White Bell Push

DP220A

White Bell Push

DPL03A

Illuminating Black Bell Push

DPL04A

Illuminating White Bell Push