Green Brook TXP400Y Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Flood Light Green Brook TXP400Y. Green Brook TXP400Y 2 pages. Portable xenon floodlight 230v/400w, 110v/400w

Print Page

1. To fit the supplied Xenon lamp you need to loosen the screw

(B) securing the hinged front cover and swing the cover down.

The lamp is attached by spring loaded holders at each end.

2. Gently locate the lamp into position ensuring good contact at

both ends. Take care not to touch the glass of the lamp, if this

does occur clean the lamp with methylated spirit.

3.Close the hinged front cover and re-tighten the top retaining

screw(B).

Note: The lighting direction cannot be adjusted downwards.

CAUTION:

This unit can become extremely hot whilst in operation, do not

touch the unit until it has had time to cool down. Make sure the

worklight is far enough away from any combustible materials

and/or surfaces. Make sure there is adequate ventilation to aid

heat dissipation.

Power Source:-

TXP400:

TXP400Y:

Lamp Wattage:-

TXP400:

TXP400Y:

IP Rating:

Power Cord:

INSTALLER - Please pass instruction manual

FITTING THE LAMP

DO NOT OVERTIGHTEN,

THIS MAY DAMAGE THE GLASS.

PART IDENTIFICATION

A. Padded Carry Handle

B. Cover Retaining Screw

C. Protective Grill

D. Angle Adjustment Control

E. Stand

F. Mains Cable

G. Worklight Bracket

TECHNICAL DATA

onto the owner of the unit

Please keep these instructions

for future reference.

WEST ROAD . HARLOW

ESSEX . CM20 2BG . UK

[email protected]

WWW.GREENBROOK.CO.UK

230V-50Hz

110V-50Hz

400W class C Xenon Tube

IP54

H05VV-F 3x1.0mm