Green Creative 38.5STRIPDIM/965/277V/R Installation Manual - Page 2

Browse online or download pdf Installation Manual for Accessories Green Creative 38.5STRIPDIM/965/277V/R. Green Creative 38.5STRIPDIM/965/277V/R 2 pages. Led strip sensor

Print Page
5.
Use one or two of the provided screws to attach the Sensor to the ceiling.
6.
If you want to connect another fixture to the Sensor, repeat Steps 3-4 on the other sides. The Sensor will control all fixtures in a connected row. The Sensor can be placed
anywhere in the row (on the end or between 2 fixtures), with a maximum of one Sensor and sixteen fixtures per row.
7.
To power the Sensor and fixture through the Sensor, open the knockout on the back of the Sensor and insert the power supply. Follow the wiring instructions provided with
the Strip Fixture.
8.
Return power back to the source and installation is complete.
fig. 1

For distant mount installation

1.
Make Sure the POWER IS TURNED OFF at the source to the location at which you are installing the product.
2.
Squeeze gently on the sides of the Sensor cover to open it. (fig. 1)
3.
Remove the QWIKLINK socket cover from the end of the fixture and from the end of the Sensor. The ends of the fixture and Sensor are marked either with A or B. When
connecting a Sensor to a fixture make sure the end marked A connects to an end marked B and vice versa. Do not connect A to A or B to B.
4.
Use one or two of the provided screws to attach the Sensor to the ceiling. (fig. 1)
5.
Plug QWIKLINK cable (WIRECON20 or WIRECON150) into the end of the fixture and Sensor. Make sure the end of the cable marked A connects with a socket marked B
and vice versa. (fig. 2)
6.
If you want to connect another fixture to the Sensor, repeat Steps 3-4 on the other sides. The Sensor will control all fixtures in a connected row. The Sensor can be placed
anywhere in the row (on the end or between 2 fixtures), with a maximum of one Sensor and sixteen fixtures per row.
7.
To power the Sensor and fixture through the Sensor, open the knockout on the back of the Sensor and insert the power supply. Follow the wiring instructions provided with
the Strip Fixture.
8.
Return power back to the source and installation is complete.
fig. 1
The Sensor is factory set with 100% Detection range, 3min Hold-Time, 10lx Daylight Threshold, +∞ Stand-by period, 30% Stand-by dimming.
To modify the setting:
With SENSORRC,
1.
Use the SENSORRC and refers to SENSORRC instructions.
Without SENSORRC
1.
Gently squeeze the sides of the Sensor diffuser and remove the lens.
2.
Refers to bellow diagram and instructions on the Sensor module to modify the settings.
fig. 2
fig. 2

LED STRIP SENSOR SETTINGS

Infrared remote receiver
Detection area
Hold-time
Daylight threshold
Stand-by period
Stand-by dimming level
GREEN CREATIVE - Tel / Fax: (866) 774-5433 - www.greencreative.com - [email protected]
Sensor antenna
Buzzer
LED indication
Daylight sensor
+
SYNC
1-10V
SYNC
For model #:22.5STRIPDIM/xxx/277V,
38.5STRIPDIM/xxx/277V/R
Where xxx means 818-965 which indicates
CRI and color temperature
fig. 3
L
N
L '
Push